跳转到主内容

修复你的物品

维修的权力

配件 & 工具

简介

Is there a tear or cut in your cord? If so, refer to this guide to replace the power cord. This guide will require some soldering experience.

  1. Before beginning, make sure the device is unplugged. With a Phillips head #2 screwdriver, begin unscrewing the four 10mm screws located on the bottom of the power base.
    • Before beginning, make sure the device is unplugged.

    • With a Phillips head #2 screwdriver, begin unscrewing the four 10mm screws located on the bottom of the power base.

  2. Once the screws are removed, pull the plastic base up gently.
    • Once the screws are removed, pull the plastic base up gently.

    • Once the plastic base is removed, there is a fan located in the center of the powerbase. Make sure the cord does not get caught or frayed by the fan.

  3. 任天堂 Switch 套装

    快速恢复到游戏的状态

    购买 Switch 套装

    任天堂 Switch 套装

    快速恢复到游戏的状态

    购买 Switch 套装
  4. Gently lift the power cord from its side slot and place it to the side.
    • Gently lift the power cord from its side slot and place it to the side.

  5. With the Phillips head #2 screwdriver, remove the two 10mm screws that secure the white bracket. The white safety bracket holds the cord down. After removing it, the cord will be free.
    • With the Phillips head #2 screwdriver, remove the two 10mm screws that secure the white bracket.

    • The white safety bracket holds the cord down. After removing it, the cord will be free.

  6. After removing the gray base and silver casing, the wires will now be free and you will have easy access to them.
    • After removing the gray base and silver casing, the wires will now be free and you will have easy access to them.

    • Gently pull out the two plastic covers at the end of the wires.

  7. Use tape or clamps to hold the wires together for an easy soldering experience.
    • Use tape or clamps to hold the wires together for an easy soldering experience.

    • Using a soldering iron, solder your new wire to the red wire.

结论

Since this guide replacement requires cutting wires, if you want to reassemble this device, you must first re-solder new wires before following the steps backwards to reassemble the device.

2等其他人完成本指南。

Geary Yu

于2015年01月22日注册

1,002 信誉积分

创作了3篇指南

团队

Cal Poly, Team 19-8, Maness Winter 2015 Cal Poly, Team 19-8, Maness Winter 2015 的会员

CPSU-MANESS-W15S19G8

4 名成员

创作了7篇指南

where am I going to be the magic bullet repair

Or

there a service center here in the philippines?

Thank u.

florentinokarenjoy24 - 回复

there a service center here in the philippines

florentinokarenjoy24 - 回复

Is there a service centre in Singapore?

I just bought the gadget in Melbourne (from Harvey Norman Nunawarding) last week. We used it yesterday but after one round of spinning, gadget went dead.

What could go round and to fix it at home?

Michael Lee - 回复

Can I plug the Magic Bullet in 220v?

Sovelita Tenerife - 回复

Where can I get a replacement cable from?

victoria hatton - 回复

添加评论

浏览统计数据:

过去的24小时: 2

过去的7天: 33

过去的30天: 186

总计 10,367