跳转到主内容

修复你的物品

维修的权力

商店

简介

Are there cracks in your casing? This guide will help you replace the casing.

  1. Use pliers to grip the gear inside of the top of the device. You may have to remove a sticker that is covering the slit at the center of the bottom before completing the next step. Insert a flathead screwdriver into the slit at the bottom of the device while still holding the pliers in place gripped on the gear.
    • Use pliers to grip the gear inside of the top of the device.

    • You may have to remove a sticker that is covering the slit at the center of the bottom before completing the next step.

    • Insert a flathead screwdriver into the slit at the bottom of the device while still holding the pliers in place gripped on the gear.

    • Lay the device on its side. Holding the screwdriver stationary to hold the bottom side in place, use the pliers to unscrew the gear by turning the pliers CLOCKWISE.

  2. Remove the four rubber pegs from the feet on the base of the Magic Bullet using the spudger.
    • Remove the four rubber pegs from the feet on the base of the Magic Bullet using the spudger.

  3. Remove the four 14.0 mm Phillips head screws in the feet of the base of the Magic Bullet using the Phillips #1 screwdriver.
    • Remove the four 14.0 mm Phillips head screws in the feet of the base of the Magic Bullet using the Phillips #1 screwdriver.

  4. Remove the black base plate.
    • Remove the black base plate.

  5. Remove the two 13.0 mm Phillips head screws from the white plastic cable guide using a Phillips #1 screwdriver.
    • Remove the two 13.0 mm Phillips head screws from the white plastic cable guide using a Phillips #1 screwdriver.

  6. Remove the white plastic cable guide.
    • Remove the white plastic cable guide.

  7. Remove the three 11.0 mm Phillips head screws surrounding the white fan blade on the base using the Phillips #1 screwdriver.
    • Remove the three 11.0 mm Phillips head screws surrounding the white fan blade on the base using the Phillips #1 screwdriver.

  8. Remove the black base.
    • Remove the black base.

  9. Remove the three white rubber spacers with the spudger.
    • Remove the three white rubber spacers with the spudger.

  10. Remove the three 11.0 mm Phillips head screws using the Phillips #1 screwdriver.
    • Remove the three 11.0 mm Phillips head screws using the Phillips #1 screwdriver.

  11. Remove the motor.
    • Remove the motor.

结论

To reassemble your device, follow these instructions in reverse order.

另外一个人完成了本指南。

Kelly McGartland

于2015年10月06日注册

467 信誉积分

创作了2篇指南

团队

Cal Poly, Team 12-13, Maness Fall 2015 Cal Poly, Team 12-13, Maness Fall 2015 的会员

CPSU-MANESS-F15S12G13

4 名成员

创作了5篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 2

过去的30天: 14

总计 958