简介

Outline what you are going to teach someone how to do.

配件

无需配件。

The battery compartment is located in the front-right side of the laptop.
  • The battery compartment is located in the front-right side of the laptop.

添加评论

To insert the battery, gently slide it into the compartment until it clicks in place.
  • To insert the battery, gently slide it into the compartment until it clicks in place.

  • To remove, slide the button highlighted in the red rectangle to the right to release the battery and slide it from the compartment.

This is not to remove the battery, this is to remove the expansion slot (which has got the floppy disk module in it, in the first picture.

blrutter - 回复

Sorry I should have mentioned it in my prior comment. The battery has got a release button on it too, but it’s part of the battery, exposed on the front face of the right front corner when the battery is installed.

blrutter - 回复

With the laptop upside down and with the battery removed, use a Torx #9 screw driver to remove the three .84 in. screws shown.
  • With the laptop upside down and with the battery removed, use a Torx #9 screw driver to remove the three .84 in. screws shown.

添加评论

Carefully pull up on the front of the keyboard to pop it out from the case. Then slide the back out so the keyboard becomes nearly free.
  • Carefully pull up on the front of the keyboard to pop it out from the case.

  • Then slide the back out so the keyboard becomes nearly free.

添加评论

Disconnect the ribbon that is connecting the keyboard to the rest of the computer. Pull the keyboard out and repair or replace as needed. Pull the keyboard out and repair or replace as needed.
  • Disconnect the ribbon that is connecting the keyboard to the rest of the computer.

  • Pull the keyboard out and repair or replace as needed.

添加评论

Remove the front plastic panel of the laptop by carefully lifting it up. Remove the front plastic panel of the laptop by carefully lifting it up. Remove the front plastic panel of the laptop by carefully lifting it up.
  • Remove the front plastic panel of the laptop by carefully lifting it up.

If they haven’t been broken off (mine just did break as I was doing this) there is a tab on each side attached to the top housing on either side of the keyboard. These tabs are on top of the tabs for the front top panel, so lifting the front end of those side housings is necessary to prevent breakage (and, given how old these suckers are, it might break anyway).

blrutter - 回复

With a Torx #9 screwdriver, remove the three .30 in. screws that hold the metal frame in place.
  • With a Torx #9 screwdriver, remove the three .30 in. screws that hold the metal frame in place.

添加评论

Remove the metal chasis that holds the hard drive. Remove the metal chasis that holds the hard drive. Remove the metal chasis that holds the hard drive.
  • Remove the metal chasis that holds the hard drive.

添加评论

In order to remove the hard drive, remove the four .22 in. screws circled in red found on both sides of the metal chassis with a Torx #9 screwdriver.
  • In order to remove the hard drive, remove the four .22 in. screws circled in red found on both sides of the metal chassis with a Torx #9 screwdriver.

添加评论

Pull the hard drive out. Pull the hard drive out.
  • Pull the hard drive out.

添加评论

结论

To reassemble your device, follow these instructions in reverse order.

另外一个人完成了本指南。

Ronan

于2011年10月10日注册

42 信誉积分

创作了4篇指南

团队

Cal Poly, Team 6-1, Regan Fall 2011 Cal Poly, Team 6-1, Regan Fall 2011 的会员

CPSU-REGAN-F11S6G1

4 名成员

创作了6篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 0

过去的30天: 0

总计 1,051