简介

The keyboard has 3 main parts, including the speaker cover, the heat sink, and the keyboard itself. You have to remove these in order to remove the keyboard.

配件

无需配件。

  1. Turn the device upside down and then locate the battery latch near the front of the device.
    • Turn the device upside down and then locate the battery latch near the front of the device.

    添加评论

  2. Slide the latch to the left to release the battery.
    • Slide the latch to the left to release the battery.

    添加评论

    • Continue holding the latch then gently pull the battery out of the device.

    • Place the battery in a safe location.

    添加评论

    • Locate the CD-ROM Drive latch.

    添加评论

    • Slide the latch to the right to release the CD ROM drive.

    添加评论

    • Continue holding the latch then gently pull the CD-ROM Drive out of the device.

    • Place the CD ROM drive in a safe location.

    添加评论

    • Locate the speaker cover.

    添加评论

  3. 传播 Fixmas 欢乐
    Get $12 off your purchase of $50 or more with code FIXMAS12
    传播 Fixmas 欢乐
    Get $12 off your purchase of $50 or more with code FIXMAS12
    • Press firmly on each end of the speaker cover and slide it to the left.

    I found it was easy to get a spudger over the left edge and lift it up a bit, then push the bar to the left, It pops right off after that.

    Jimmy James - 回复

    • Gently lift the speaker cover to remove it.

    添加评论

    • Lift the keyboard up from the back using a spudger(wedge side).

    添加评论

    • Gently lift the keyboard until only the ribbon cable remains attached.

    添加评论

    • Tilt the keyboard away from the screen.

    添加评论

    • Locate the six screws that secure the heatsink.

    This is not necessary to remove the HDD. Go directly to step 20.

    Kenneth DeVries - 回复

    That isn't the HDD!

    Dix Dox - 回复

    • Remove the six screws from the heatsink using the Philips #1 screwdriver.

    添加评论

    • Lift the heatsink from the side closest to the laptop screen.

    添加评论

    • Remove the heatsink.

    添加评论

    • Gently pull up on the beige ribbon lock until it moves a short distance on both sides to separate the ribbon cable from the connector.

    添加评论

    • Detach the ribbon cable.

    添加评论

    • Remove the keyboard.

    添加评论

结论

To reassemble your device, follow these instructions in reverse order.

另外一个人完成了本指南。

Sean Bent

于2011年04月01日注册

41 信誉积分

撰写一个指南

团队

Cal Poly, Team 10-39, Forte Spring 2011 Cal Poly, Team 10-39, Forte Spring 2011 的会员

CPSU-FORTE-S11S10G39

5 名成员

创作了6篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 1

过去的30天: 7

总计 1,924