修复你的物品 社区 商店

MacBook Pro 15" Unibody Mid 2012 Right Fan Replacement

简介

Use this guide to replace the right fan.

你所需要的

  1. MacBook Pro 15" Unibody Mid 2012 Right Fan Replacement, Lower Case: 步骤 1 中的图像 1，1

    • Remove the following ten screws securing the lower case to the upper case:

    • Three 13.5 mm (14.1 mm) Phillips screws.

    • Seven 3 mm Phillips screws.

    • When removing these screws, note how they come out at a slight angle. They must be reinstalled the same way.

    编辑

  2. MacBook Pro 15" Unibody Mid 2012 Right Fan Replacement: 步骤 2 中的图像 1，1

    • Using both hands, lift the lower case near the vent to pop it off two clips securing it to the upper case.

    • Remove the lower case and set it aside.

    编辑

  3. MacBook Pro 15" Unibody Mid 2012 Right Fan Replacement, Battery Connector: 步骤 3 中的图像 1，2 MacBook Pro 15" Unibody Mid 2012 Right Fan Replacement, Battery Connector: 步骤 3 中的图像 2，2

    • For certain repairs (e.g. hard drive), disconnecting the battery connector is not necessary but is recommended as it prevents any accidental shorting of electronics on the motherboard. If you do not disconnect the battery connector, please be careful as parts of the motherboard might be electrified.

    • Use the edge of a spudger to pry the battery connector upwards from its socket on the logic board.

    • It is useful to pry upward on both short sides of the connector to "walk" it out of its socket.

    编辑

  5. MacBook Pro 15" Unibody Mid 2012 Right Fan Replacement: 步骤 4 中的图像 1，1

    • Bend the battery cable slightly away from its socket on the logic board so it does not accidentally connect itself while you work.

    编辑

  6. MacBook Pro 15" Unibody Mid 2012 Right Fan Replacement, Right Fan: 步骤 5 中的图像 1，3 MacBook Pro 15" Unibody Mid 2012 Right Fan Replacement, Right Fan: 步骤 5 中的图像 2，3 MacBook Pro 15" Unibody Mid 2012 Right Fan Replacement, Right Fan: 步骤 5 中的图像 3，3

    • Use a spudger to pry the fan connector straight up off the logic board.

    • It is useful to twist the spudger axially from beneath the fan cable wires to release the connector.

    • The fan socket and the fan connector can be seen in the second and third pictures. Be careful not to break the plastic fan socket off the logic board as you use your spudger to lift the fan connector straight up and out of its socket. The layout of the logic board shown in the second picture may look slightly different than your machine but the fan socket is the same.

    编辑

  7. MacBook Pro 15" Unibody Mid 2012 Right Fan Replacement: 步骤 6 中的图像 1，1

    • Remove three T6 Torx screws securing the right fan to the logic board and upper case.

    编辑

  8. MacBook Pro 15" Unibody Mid 2012 Right Fan Replacement: 步骤 7 中的图像 1，1

    • Lift the right fan out of the upper case.

    编辑
结论

To reassemble your device, follow these instructions in reverse order.

31等其他人完成本指南。

作者

与3其他贡献者

Andrew Optimus Goldheart

于10/17/09注册

502,789 声望

创作了407篇指南

徽章: 44

+ 41更多徽章

团队

iFixit iFixit 的会员

Staff

135 名成员

创作了16,767篇指南

0条评论

添加评论

浏览统计数据:

过去 24 小时： 0

过去 7 天： 13

过去 30 天： 49

总计 10,681