修复你的物品

维修的权力

配件 & 工具

MacBook Pro 15" Unibody Mid 2009 Left Fan Replacement

撰写者： Walter Galan (和另外6个贡献者)
  • 评论： 4
  • 收藏 15
  • 完成 69

难度

中等

步骤

4

所需时间

5 - 40 分钟

节

2

标志

0

简介

Replace a faulty fan to keep temperatures down.

  1. Remove the following ten screws securing the lower case to the upper case:

    • Remove the following ten screws securing the lower case to the upper case:

    • Seven 3 mm Phillips screws.

    • Three 13.5 mm Phillips screws.

    翻译

  2. Using both hands, lift the lower case near the vent to pop it off two clips securing it to the upper case. Remove the lower case and set it aside.

    • Using both hands, lift the lower case near the vent to pop it off two clips securing it to the upper case.

    • Remove the lower case and set it aside.

    翻译

  3. 任天堂 Switch 套装

    快速恢复到游戏的状态

    购买 Switch 套装

    任天堂 Switch 套装

    快速恢复到游戏的状态

    购买 Switch 套装

  4. Use the flat end of a spudger to disconnect the left fan connector from the logic board. It is useful to twist the spudger axially from beneath the fan cable wires to release the connector. The fan socket and the fan connector can be seen in the second and third pictures. Be careful not to break the plastic fan socket off the logic board as you use your spudger to lift the fan connector straight up and out of its socket. The layout of the logic board shown in the second picture may look slightly different than your machine but the fan socket is the same.

    • Use the flat end of a spudger to disconnect the left fan connector from the logic board.

    • It is useful to twist the spudger axially from beneath the fan cable wires to release the connector.

    • The fan socket and the fan connector can be seen in the second and third pictures. Be careful not to break the plastic fan socket off the logic board as you use your spudger to lift the fan connector straight up and out of its socket. The layout of the logic board shown in the second picture may look slightly different than your machine but the fan socket is the same.

    翻译

  5. Remove three T6 Torx screws securing the left fan to the logic board. Lift the left fan out of the upper case.

    • Remove three T6 Torx screws securing the left fan to the logic board.

    • Lift the left fan out of the upper case.

    翻译
结论

To reassemble your device, follow these instructions in reverse order.

69等其他人完成本指南。

3条评论

添加一条评论

Connecting the fan to the logic board is unclear. Could you walk through that a little more clearly?

kamoako1 - 回复

When connecting the new fan to the logic board, set the connector piece above its socket on the logic board and then gently press down. It should click together.

k. -

quite easy. i’m very happy with this manual. Though connecting the new fan until it clicks is the most difficult part. thank you!

Oliver - 回复

添加评论

浏览统计数据:

过去的24小时： 1

过去的7天： 8

过去的30天： 43

总计 40,477