当前版本的文档还未经巡查，您可以查看最新的已查核版本。
这个步骤还没有翻译 帮忙翻译一下
With the case closed, place the Unibody top-side down on a flat surface.
Depress the grooved side of the access door release latch enough to grab the free end. Lift the release latch until it is vertical.
The access door should now be raised enough to lift it up and out of the Unibody.
在继续操作之前，请确保电池卡扣是垂直的。
抓住半透明的塑料卡扣，将电池向上拉出一体化机。
如果按下卡扣，它将把电池锁定到位。
拧下将下底壳固定到机箱的以下八颗螺丝：
一颗 5.4 mm 菲利普斯十字螺丝。
三颗 14 mm 菲利普斯十字螺丝。
四颗 3.5 mm 菲利普斯十字螺丝。
用两只手提起下底壳，使其脱离上壳体。
Disconnect the camera cable by pulling the male end straight away from its socket.
Deroute the camera data cable from the channel in the optical drive.
Use a spudger to pry the optical drive connector straight up off the logic board.
Remove two 8 mm Phillips screws securing the camera cable bracket to the upper case.
The rightmost screw may remain captive in the camera cable.
Lift the camera cable bracket out from the upper case.
Remove the following three Phillips screws securing the optical drive to the upper case:
One 3.5 mm Phillips screw.
Two 2.5 mm Phillips screws.
Lift the optical drive from its left edge and pull it out of the computer.
Using the flat end of a spudger, pry the subwoofer connector straight up off the logic board.
Remove the following four screws securing the subwoofer and right speaker to the upper case:
Two 3.2 mm Phillips screws.
One 2.6 mm Phillips screw.
One 5 mm Phillips screw.
Lift the subwoofer and right speaker assembly out of the upper case.
取消：我没有完成这个指南。
21等其他人完成本指南。
与5其他贡献者
694,782 声望
创作了1,203篇指南
徽章: 54
+ 51更多徽章
选择一个尺寸并复制下面的代码，将本指南作为一个小插件嵌入到你的网站/论坛中。
过去 24 小时： 1
过去 7 天： 15
过去 30 天： 36
总计 27,710
