简介

Replace a faulty Bluetooth board using this guide.

Power down your Mac mini, disconnect all of the cables, and flip it over.
  • Power down your Mac mini, disconnect all of the cables, and flip it over.

  • Insert the Jimmy into the crack between the aluminum top housing and the plastic lower housing.

  • The Jimmy should reach a stop about 3/8" down.

添加评论

Gently bend the Jimmy outwards to pry the crack open a little larger and lift the lower housing up a small amount.
  • Gently bend the Jimmy outwards to pry the crack open a little larger and lift the lower housing up a small amount.

  • There are several plastic clips on the lower housing that fit into a channel in the aluminum top housing. Your goal is to use the Jimmy to push these clips inward enough to free them from the channel, while gently pulling up on the lower housing.

添加评论

  • Once you have the first side free, rotate the Mac mini and start prying up on the front edge.

  • Use the same prying motion to both bend the clips inward and lift the lower housing up out of the top housing.

添加评论

  • You may need to move the Jimmy along the edge to pry up all of the clips. Be patient and do a little bit at a time.

添加评论

  • Keep working around the perimeter, freeing the clips along the final edge.

添加评论

  • Flip the Mac mini back over and lift the top housing off of the lower housing.

添加评论

  • Remove the single Phillips screw securing the Bluetooth board to the internal frame.

添加评论

  • Disconnect the Bluetooth cable connector by pulling it straight away from its socket.

添加评论

  • Use the flat end of a spudger to pry the Bluetooth antenna cable connector up off the Bluetooth board.

添加评论

结论

To reassemble your device, follow these instructions in reverse order.

5等其他人完成本指南。

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 0

过去的30天: 11

总计 7,434