修复你的物品 社区 商店

M3D Micro Motor Replacement

简介

When printing, your extruder may not work properly, the reason of this may be related to one of the two motors. If you determined that one of the motors could be the ones causing trouble, you will need to replace it. Through this guide we intend to show the step by step process that one must take to safely remove and replace the motor of a M3D Micro.

你所需要的

  1. M3D Micro Motor Replacement, M3D Micro Frame Removal: 步骤 1 中的图像 1，1

    • Removing the frame is necessary to access the z axis belt, motors and ports. Make sure the unit is unplugged and set on a hard level surface.

    编辑

  2. M3D Micro Motor Replacement: 步骤 2 中的图像 1，3 M3D Micro Motor Replacement: 步骤 2 中的图像 2，3 M3D Micro Motor Replacement: 步骤 2 中的图像 3，3

    • Pull the x-rods away from the plastic sliders on the y-rods, and flip the slider upwards to release the tracks. Lift the extruder assembly out of the way.

    编辑

  3. M3D Micro Motor Replacement: 步骤 3 中的图像 1，2 M3D Micro Motor Replacement: 步骤 3 中的图像 2，2

    • No tools are required to remove the frame. Press down on the printing bed with your thumbs while lifting the frame with your fingers. The frame easily slides up.

    编辑

  5. M3D Micro Motor Replacement, Motor: 步骤 4 中的图像 1，1

    • Once the base is opened you should find a circuit board and two motors like the one on the right, select the motor to be replaced.

    编辑

  6. M3D Micro Motor Replacement: 步骤 5 中的图像 1，2 M3D Micro Motor Replacement: 步骤 5 中的图像 2，2

    • Unplug the connectors for the Orange, Blue, Gray and Black cables. These would be the motor cables.

    编辑

  7. M3D Micro Motor Replacement: 步骤 6 中的图像 1，2 M3D Micro Motor Replacement: 步骤 6 中的图像 2，2

    • Once disconnected you will proceed to lift the motor using pliers.

    编辑

  8. M3D Micro Motor Replacement: 步骤 7 中的图像 1，2 M3D Micro Motor Replacement: 步骤 7 中的图像 2，2

    • Now, remove the motor.

    编辑
结论

To reassemble your device, follow these instructions in reverse order.

作者

与3其他贡献者

Miguel Pina

于10/17/17注册

101 声望

撰写一个指南

徽章: 2

团队

USF Tampa, Team S3-G2, Nance Fall 2017 USF Tampa, Team S3-G2, Nance Fall 2017 的会员

USFT-NANCE-F17S3G2

4 名成员

创作了10篇指南

一条评论

Hello, good work and explanation. Is there any possibility to replace MICRO+ X-AXIS MOTOR “gear” please. Thanks

robozeka - 回复

添加评论

浏览统计数据:

过去 24 小时： 0

过去 7 天： 7

过去 30 天： 19

总计 1,594