跳转到主内容

简介

Overtime, the paper feeder and motor will become likely to wear out. You may notice a paper jam in your printer if the motor isn’t working properly. If the paper is not feeding properly through your LifePrint 2x3, the motor could be wearing out. Use this guide to replace the motor/paper feeder in your device.

  1. LifePrint 2x3 Motor-Feeder Replacement, Motor-Feeder: 步骤 1 中的图像 1,3 LifePrint 2x3 Motor-Feeder Replacement, Motor-Feeder: 步骤 1 中的图像 2,3 LifePrint 2x3 Motor-Feeder Replacement, Motor-Feeder: 步骤 1 中的图像 3,3
    • Make sure the top of the Lifeprint is facing upwards displaying the Lifeprint logo.

    • Slide open the top cover and remove the top lid.

  2. LifePrint 2x3 Motor-Feeder Replacement: 步骤 2 中的图像 1,3 LifePrint 2x3 Motor-Feeder Replacement: 步骤 2 中的图像 2,3 LifePrint 2x3 Motor-Feeder Replacement: 步骤 2 中的图像 3,3
    • Remove the six screws on the outer sides of the device with the Phillips #00 screwdriver.

    • The motor is highlighted in orange.

  3. LifePrint 2x3 Motor-Feeder Replacement: 步骤 3 中的图像 1,2 LifePrint 2x3 Motor-Feeder Replacement: 步骤 3 中的图像 2,2
    • After removing the six screws, gently flip the device over so the bottom cover is facing you.

    • Remove the bottom cover by using the opening pick.

  4. LifePrint 2x3 Motor-Feeder Replacement: 步骤 4 中的图像 1,3 LifePrint 2x3 Motor-Feeder Replacement: 步骤 4 中的图像 2,3 LifePrint 2x3 Motor-Feeder Replacement: 步骤 4 中的图像 3,3
    • Remove the four screws using the Phillips #00 screwdriver to access the motor and sensor (highlighted in orange).

  5. LifePrint 2x3 Motor-Feeder Replacement: 步骤 5 中的图像 1,3 LifePrint 2x3 Motor-Feeder Replacement: 步骤 5 中的图像 2,3 LifePrint 2x3 Motor-Feeder Replacement: 步骤 5 中的图像 3,3
    • Remove the component holding the motor and feeder.

    • Using a spudger remove the top piece of the component to get to the motor and feeder.

    • Remove the motor and feeder assembly from the device.

结论

To reassemble your device, follow these instructions in reverse order.

Calli Brown

于2019年09月24日注册

172 声望分

撰写一个指南

0条评论

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 1

过去的30天: 4

总计 138