跳转到主内容

简介

If your device isn’t properly registering clicks or if the cursor isn’t properly tracking your finger movements, it may be time to replace the trackpad. Follow these instructions to replace the trackpad in the Lenovo Yoga 910-13IKB.

  1. Turn the laptop over and remove the ten Torx T5 screws along the perimeter of the bottom panel.
    • Turn the laptop over and remove the ten Torx T5 screws along the perimeter of the bottom panel.

    • Remove the back panel from the device.

  2. Remove the four 3 mm Phillips screws holding the battery in place.
    • Remove the four 3 mm Phillips screws holding the battery in place.

  3. Disconnect the battery cable from its motherboard socket by gently pulling it towards the battery. Pull parallel to the battery, not straight up. Pull evenly on the width of the cable so that no individual wire is overly strained.
    • Disconnect the battery cable from its motherboard socket by gently pulling it towards the battery.

    • Pull parallel to the battery, not straight up.

    • Pull evenly on the width of the cable so that no individual wire is overly strained.

    • Lift the battery out.

  4. Using the Phillips #0 screwdriver, remove all six screws holding the trackpad to the device. Find the ribbon cable, the black bundle of wires attached to the trackpad, and lift the head of the ribbon cable towards you. Carefully lift up the trackpad and remove it from the device.
    • Using the Phillips #0 screwdriver, remove all six screws holding the trackpad to the device.

    • Find the ribbon cable, the black bundle of wires attached to the trackpad, and lift the head of the ribbon cable towards you.

    • Carefully lift up the trackpad and remove it from the device.

结论

To reassemble your device, follow these instructions in reverse order.

0条评论

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 1

过去的30天: 2

总计 66