跳转到主内容

简介

This guide will teach you how to remove the built in speakers when they begin to fail or are entirely unresponsive.

Guide Notes

  • The keyboard must be removed before the plastic top case can be removed.
  • When separating the keyboard assembly from the laptop, be mindful of the unseen ribbon cable that must be disconnected.
  • The touchpad, like the keyboard, has a ribbon cable that must be disconnected while raising the cover away from the body of the laptop.
  1. Remove the battery.
    • Remove the battery.

    • Unfortunately, the battery isn't pictured because our device did not come with a battery at the time of the creation of this guide.

  2. Loosen (do not remove) the 14.0mm screw in the DIMM slot cover with a Phillips #2 screwdriver. Loosen (do not remove) the 14.0mm screw in the DIMM slot cover with a Phillips #2 screwdriver.
    • Loosen (do not remove) the 14.0mm screw in the DIMM slot cover with a Phillips #2 screwdriver.

  3. Pry loose the top left key-covers with a plastic opening tool.
    • Pry loose the top left key-covers with a plastic opening tool.

  4. Nudge the plastic tabs around the keyboard using the plastic opening tool while lifting it with a spudger. Ensure all 5 clips are loosened from the front of the keyboard before removing.
    • Nudge the plastic tabs around the keyboard using the plastic opening tool while lifting it with a spudger.

    • Ensure all 5 clips are loosened from the front of the keyboard before removing.

  5. Slowly raise keyboard away from the laptop. A short ribbon must be removed before keyboard is free.
    • Slowly raise keyboard away from the laptop. A short ribbon must be removed before keyboard is free.

    • Remove the keyboard from the device.

  6. Remove the six 14.0mm screws with a Phillips #0 screwdriver.
    • Remove the six 14.0mm screws with a Phillips #0 screwdriver.

    • Remove the three 3.0mm screws with a Phillips #0 screwdriver.

  7. Snap off the top cover with a plastic opening tool, ensuring that the tabs don't snap back on.
    • Snap off the top cover with a plastic opening tool, ensuring that the tabs don't snap back on.

  8. Lift the top panel off of the device.
    • Lift the top panel off of the device.

    • Lift the panel slowly in order to not damage the orange ribbon cable.

  9. Detach the ribbon cable as shown in the picture.
    • Detach the ribbon cable as shown in the picture.

  10. Remove the four 3.0mm screws with a Phillips #0 screwdriver. Remove the four 3.0mm screws with a Phillips #0 screwdriver.
    • Remove the four 3.0mm screws with a Phillips #0 screwdriver.

  11. Using the Precision Tweezers, remove the speaker cable from the connector.
    • Using the Precision Tweezers, remove the speaker cable from the connector.

    • Remove the speaker from the device.

结论

To reassemble your device, follow these instructions in reverse order.

4等其他人完成本指南。

Gabriel Cordova

于2017年10月02日注册

619 信誉积分

创作了4篇指南

团队

USF Tampa, Team S1-G2, Thompson Fall 2017 USF Tampa, Team S1-G2, Thompson Fall 2017 的会员

USFT-THOMPSON-F17S1G2

4 名成员

创作了6篇指南

0条评论

添加评论

浏览统计数据:

过去的24小时: 1

过去的7天: 2

过去的30天: 19

总计 952