跳转到主内容

简介

If your computer won't boot and is having hard disk/hard drive reading errors, follow this guide to replace it. The guide shows how to remove the back from the device, unscrew the battery from the device, remove the drive from the dock, and unscrew the drive housing.

  1. Before you proceed, make sure your computer is turned off and it's not connected to any power source. Before removing the drive, make a backup copy of all the information on it if possible. Never remove the drive while the system is operating or in suspend mode. Place laptop with the bottom facing up. Using a Philip #1 screwdriver unscrew all 13 screws. Gently pry the back out using a plastic opening tool, starting from one of the corners.
    • Before you proceed, make sure your computer is turned off and it's not connected to any power source. Before removing the drive, make a backup copy of all the information on it if possible. Never remove the drive while the system is operating or in suspend mode.

    • Place laptop with the bottom facing up. Using a Philip #1 screwdriver unscrew all 13 screws. Gently pry the back out using a plastic opening tool, starting from one of the corners.

  2. Using a Phillips #1 screwdriver, remove the four (5mm) screws holding the hard drive in place.
    • Using a Phillips #1 screwdriver, remove the four (5mm) screws holding the hard drive in place.

  3. Do not lift hard drive straight up otherwise you might risk breaking the connection port. Gently slide the hard drive away  and out out of the connection port.
    • Do not lift hard drive straight up otherwise you might risk breaking the connection port.

    • Gently slide the hard drive away and out out of the connection port.

  4. Using a Philip #1 screwdriver remove 2 screws from each side, (removing 4 screws in total) holding the hard drive into the housing. Using a Philip #1 screwdriver remove 2 screws from each side, (removing 4 screws in total) holding the hard drive into the housing.
    • Using a Philip #1 screwdriver remove 2 screws from each side, (removing 4 screws in total) holding the hard drive into the housing.

  5. Remove hard drive from housing.
    • Remove hard drive from housing.

结论

To reassemble your device, follow these instructions in reverse order with your new replacement hard drive.

14等其他人完成本指南。

Saddam Alsinai

于2017年10月18日注册

660 信誉积分

创作了4篇指南

团队

UW Tacoma, Team S3-G4, Liner Fall 2017 UW Tacoma, Team S3-G4, Liner Fall 2017 的会员

UWT-LINER-F17S3G4

4 名成员

创作了14篇指南

3条评论

Unplug or remove battery first?

Chris Quirke - 回复

you do not need to unplug or remove the battery

Holden Phillips - 回复

添加评论

浏览统计数据:

过去的24小时: 4

过去的7天: 37

过去的30天: 92

总计 17,703