简介
In order to access and replace internal components such as the front camera or screen assembly, you must remove the front cover of the tablet.
你所需要的
-
-
Turn the tablet so the back is visible.
-
One at a time, remove the battery covers by sliding them towards the sides and away from the center of the device.
-
-
-
Use a Phillips #1 screwdriver to remove the following screws from the device:
-
Four 7.0mm Phillips screws
-
Three 6.0mm Phillips screws
-
Two 10.0mm Phillips screws
-
-
-
Use a small plastic opening tool to begin separating the colored front cover from the white rear cover of the device.
-
With one hand on the front cover and one hand on the rear cover, start from the bottom of the device and begin pulling the pieces apart.
-
Once only the top edge remains connected, simultaneously pull the rear cover backwards away from the front cover and upwards towards the top of the device. This should release the last remaining tabs holding the pieces together.
-
-
-
Use a Phillips #1 screwdriver to remove two 5.5mm screws from the plastic speaker holder.
-
-
-
-
Locate the following:
-
Two negative battery terminals.
-
Two negative battery wire glue-points.
-
One terminal at a time, pinch the battery side of the terminal towards the wire side of the terminal with a finger or thumb, and pull upwards away from the front cover to release the terminal from the cover.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.