简介

Steps to remove the LG VX8550 scroll wheel

Slide the battery release up.
  • Slide the battery release up.

添加评论

Remove the battery by lifting away from the case.
  • Remove the battery by lifting away from the case.

添加评论

  • Remove the 2 screw covers next to the rear speaker with a Push Pin.

添加评论

  • Remove the 4 cover screws with a Philips #00 screwdriver.

添加评论

  • Use the iPod opening tool to pry off the back casing.

添加评论

  • Continue sliding the iPod opening tool around the seam of the casing to separate the front and back casings.

添加评论

  • Separate the casing halves.

  • Be sure to keep track of the side buttons as they fall out.

添加评论

  • Remove the 2 screws from the back of the phone with a Phillips #00 Screwdriver.

添加评论

  • Carefully lift up on the motherboard to see the ribbon cables underneath.

  • Use the spudger to carefully disconnect the ribbon cable from the motherboard.

添加评论

  • Remove the motherboard from the front casing by lifting straight up.

添加评论

  • Lay the phone with the screen facedown.

  • The 6 slider screws are visible.

添加评论

  • Peel back but don't remove the blue tape to access the 2 center screws.

  • Remove the 6 slider screws with the Phillips #00 screwdriver.

添加评论

  • Lift the keypad housing away from the slider.

添加评论

  • Remove the 2 screw covers next to the speaker with a push pin next to the camera.

添加评论

  • Remove the 6 screws with a Phillips #00 Screwdriver.

添加评论

  • Use the ipod opening tool to pry the screen casing and the slider mechanism apart from each other.

添加评论

  • Carefully lift the slider mechanism to see the ribbon cables underneath.

添加评论

  • Slide ribbon cable through the slider mechanism.

添加评论

  • Separate the two halves.

添加评论

  • With the spudger, lift up under the connector to unplug it from the circuit board.

添加评论

  • Lift and remove the blue tape from screen connector.

添加评论

  • Lift the top edge of the screen using a pin to pry under the corner.

添加评论

  • Grasp the ribbon cable near the connector and carefully slide it out of the white connector.

  • It is helpful to gently wiggle the ribbon cable from side to side.

添加评论

  • Carefully lift the circuit board away from the screen casing using Ipod Opening Tool.

  • Peel the circuit board away from the adhesive backing with your finger.

添加评论

  • Remove the scroll wheel from the casing with your hands.

添加评论

结论

To reassemble your device, follow these instructions in reverse order.

另外一个人完成了本指南。

Nathan Jones

于2010年04月10日注册

83 信誉积分

创作了20篇指南

团队

Cal Poly, Team 34-55, Forte Spring 2010 Cal Poly, Team 34-55, Forte Spring 2010 的会员

CPSU-FORTE-S10S34G55

5 名成员

创作了20篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 0

过去的30天: 1

总计 2,250