简介

This guide is designed to remove or replace the logic board of the LG VX6000.

Locate the dark gray tab on the back of the phone towards the top.
  • Locate the dark gray tab on the back of the phone towards the top.

  • Push the tab towards the top of the phone to release the battery.

Remove the battery by lifting up and rotating the battery away from the bottom edge.
  • Remove the battery by lifting up and rotating the battery away from the bottom edge.

添加评论

Set the battery aside in a safe location.
  • Set the battery aside in a safe location.

添加评论

Pull out the two rubber cushions located on the top of the phone using tweezers.
  • Pull out the two rubber cushions located on the top of the phone using tweezers.

  • Only remove the two cushions that are circled!

添加评论

Unscrew the six screws seen on the back using a Phillips 00 Screwdriver.
  • Unscrew the six screws seen on the back using a Phillips 00 Screwdriver.

  • Remove screws and carefully place on a uncluttered surface or in a small container.

  • The screws are small and easily lost.

添加评论

Remove the back of the phone using your hands.
  • Remove the back of the phone using your hands.

  • There is a pair of red and blue wires that plugs into the motherboard. These wires will snap if you force the pieces apart.

  • Remove the back of the phone very gently. Use your fingernail or tweezers to unplug the wires.

  • To reattach the back, you must plug these wires back in.

添加评论

Locate the adhesive tab located towards the top of the phone as indicated in the photo.
  • Locate the adhesive tab located towards the top of the phone as indicated in the photo.

  • Remove the tab by carefully peeling it off.

  • The tab should not fully separate from the phone.

添加评论

Locate the yellow connection towards the top of the phone. This is directly connected to the screen. Remove the connector by carefully prying it away from the motherboard and lifting it away from the phone
  • Locate the yellow connection towards the top of the phone. This is directly connected to the screen.

  • Remove the connector by carefully prying it away from the motherboard and lifting it away from the phone

  • Do not pull too hard on the connector.

添加评论

Gently lift a corner of the motherboard away from the casing to remove.
  • Gently lift a corner of the motherboard away from the casing to remove.

添加评论

结论

To reassemble your device, follow these instructions in reverse order.

Adam Altman

于2010年01月14日注册

1 信誉积分

创作了6篇指南

团队

Cal Poly, Team 4-11, Forte Winter 2010 Cal Poly, Team 4-11, Forte Winter 2010 的会员

CPSU-FORTE-W10S4G11

5 名成员

创作了10篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 0

过去的30天: 0

总计 3,019