跳转到主内容

简介

A guide to replace the antenna.

配件

没有特定配件。

  1. Turn the phone on its back. Turn the phone on its back.
    • Turn the phone on its back.

  2. Orient the phone as shown. Remove the battery cover by pushing upward with your thumb.
    • Orient the phone as shown.

    • Remove the battery cover by pushing upward with your thumb.

  3. Place your fingernail at the top of the battery and pry the battery out towards you. Place your fingernail at the top of the battery and pry the battery out towards you.
    • Place your fingernail at the top of the battery and pry the battery out towards you.

  4. Orient the phone as shown with the battery already removed.
    • Orient the phone as shown with the battery already removed.

  5. Macbook 电池维修套装

    起价 $69.99

    Buy Now

    Macbook 电池维修套装

    起价 $69.99

    Buy Now
  6. Remove the 2 plastic plugs located on the side and upper quadrant of the rear body panel by using the push-pin and lifting outwards. Use a Phillips #00 screwdriver to remove the 5 screws as shown here. Use a Phillips #00 screwdriver to remove the 5 screws as shown here.
    • Remove the 2 plastic plugs located on the side and upper quadrant of the rear body panel by using the push-pin and lifting outwards.

    • Use a Phillips #00 screwdriver to remove the 5 screws as shown here.

  7. Place an iPod opener tool in the seam above the antenna. Run the tool around the perimeter of the entire phone. Run the tool around the perimeter of the entire phone.
    • Place an iPod opener tool in the seam above the antenna.

    • Run the tool around the perimeter of the entire phone.

  8. Check to see that your device looks like the attached photo.
    • Check to see that your device looks like the attached photo.

  9. Locate the screw and copper fixture that hold the antenna in place.
    • Locate the screw and copper fixture that hold the antenna in place.

    • Remove the screw from the device using a Philips #00 screwdriver.

  10. Remove the copper fixture after it has been unscrewed. Remove the copper fixture after it has been unscrewed.
    • Remove the copper fixture after it has been unscrewed.

  11. Check to see that your device looks like the attached photo. Check to see that your device looks like the attached photo.
    • Check to see that your device looks like the attached photo.

结论

To reassemble your device, follow these instructions in reverse order.

Douglas Blaalid

于2010年01月13日注册

282 信誉积分

创作了8篇指南

团队

Cal Poly, Team 4-13, Forte Winter 2010 Cal Poly, Team 4-13, Forte Winter 2010 的会员

CPSU-FORTE-W10S4G13

5 名成员

创作了15篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 0

过去的30天: 0

总计 2,313