1. Push the light gray rectangle in the top-center up.
    • Push the light gray rectangle in the top-center up.

    • While pushing up grab the sides of the battery and pull out.

    添加评论

  2. Unscrew the antenna by grasping the base and twisting counterclockwise.
    • Unscrew the antenna by grasping the base and twisting counterclockwise.

      • The antenna may separate from a black sleeve during removal. You may need to use tweezers to remove the sleeve. Remove both the antenna and the sleeve and set aside.

    添加评论

  3. 订单满 $20 免运费
    结账时使用优惠码 BLUEANDBLACK
    订单满 $20 免运费
    使用优惠码 BLUEANDBLACK
    • The phone may have a rubber insert in the bottom of the phone (see picture). If this rubber insert exists, remove it from the bottom of phone and set aside.

    添加评论

    • Using a Torx screwdriver with a T6-sized bit, unscrew the four screws on the back of the phone.

      • The bit size is engraved on the base of the bit head.

    添加评论

    • With the phone flipped open, wedge the back cover from the faceplate by running the tip of the plastic opening tool around the seam on the back of the phone.

    • Gently pull the two pieces apart to separate.

      • Apply enough force to separate the pieces without cracking the back cover.

    添加评论

    • Lift the computer chip to gain access to the keypad and side buttons beneath.

      • CAUTION: The computer chip is attached with a thin ribbon wire at upper right corner of case. DO NOT BREAK THE RIBBON WIRE.

    添加评论

结论

<b>To reassemble your device, follow these instructions in reverse order.</b>

Nico Chiarito

于2010年01月21日注册

22 信誉积分

创作了5篇指南

团队

Cal Poly, Team 8-47, Regan Winter 2010 Cal Poly, Team 8-47, Regan Winter 2010 的会员

CPSU-REGAN-W10S8G47

5 名成员

创作了8篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 0

过去的30天: 0

总计 2,438