简介

This guide explains how to replace the Case of a LG Neon GT 365 phone

  1. Remove the back cover of the phone by pushing the rectangular button located on the back top-side of the phone.
    • Remove the back cover of the phone by pushing the rectangular button located on the back top-side of the phone.

    添加评论

  2. Use the appropriate screw driver head and remove the six black screws as shown in the picture. A screw may be covered by the slide spring. Move the slide spring to the other side to access that screw.
    • Use the appropriate screw driver head and remove the six black screws as shown in the picture. A screw may be covered by the slide spring. Move the slide spring to the other side to access that screw.

    添加评论

    • Use the plastic opening tool to go around the seem and slowly pull off slide spring assembly.

    • Make sure the ribbon connector does not get caught on other parts of the phone.

    添加评论

    • Remove the connector ribbon located near the bottom of the phone by pulling gently on the ribbon.

    添加评论

  3. 传播 Fixmas 欢乐
    Get $12 off your purchase of $50 or more with code FIXMAS12
    传播 Fixmas 欢乐
    Get $12 off your purchase of $50 or more with code FIXMAS12
    • Carefully, peel off the two green pieces of tape then the gold tape.

    添加评论

    • Disconnect the copper colored ribbon. It is fine to leave the copper ribbon ttached to the top of the phone.

    添加评论

    • Use the plastic opening tool and go around the silver screen and begin to lift it up.

    • Once the silver screen has been lifted up slightly, slide the bottom half of the green circuit board located below the screen off of the phone. Then continue popping the screen out.

    添加评论

    • Once the silver screen has been lifted up slightly, slide the bottom half of the green circuit board located below the screen off of the phone.

    添加评论

    • Disconnect left side of this ribbon.

    • By disconnecting the left side of that ribbon, the phone's screen can be removed from the outer shell.

    添加评论

    • Use the plastic opening tool to remove that speaker out of the groove.

    • Use the plastic opening tool to remove the copper colored plate that the speaker and ribbon is attached to out of the phone.

    添加评论

    • Peel the rubber front keypad out of the case.

    添加评论

    • At this point, all of removable phone components has been taken out. With the new case, follow the steps in reverse to reassemble.

    添加评论

结论

To reassemble your device, follow these instructions in reverse order.

kristie

于2013年10月23日注册

538 信誉积分

创作了5篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 1

过去的30天: 1

总计 220