简介

This guide will help you through the process of replacing the LG Muziq's keypad.

  1. Slide the battery cover release towards top of phone. Place one finger at each side of the battery cover.
    • Slide the battery cover release towards top of phone.

    • Place one finger at each side of the battery cover.

    • Lift and remove the battery cover.

  2. Place a finger at the top corner of the battery and lift out of the phone. Place a finger at the top corner of the battery and lift out of the phone.
    • Place a finger at the top corner of the battery and lift out of the phone.

  3. Use the spudger to lift up the two screw covers at the top of the phone. Remove all four Phillips#00 (3.3mm) screws with screwdriver.
    • Use the spudger to lift up the two screw covers at the top of the phone.

    • Remove all four Phillips#00 (3.3mm) screws with screwdriver.

  4. 所有超过US$100.00或包含 Pro Tech工具包的订单免费送货!

    浏览我们的商店

    善于维修,即天赋异禀。

    与 #ImAGenius 分享您的维修故事

    我们都是天才

    与 #ImAGenius 分享您的维修故事

  5. Use the spudger to lift up the rear case from the phone. Note: Rear case is connected on all sides and will have to be detached on all sides before removal. Remove the rear case from the device.
    • Use the spudger to lift up the rear case from the phone.

    • Note: Rear case is connected on all sides and will have to be detached on all sides before removal.

    • Remove the rear case from the device.

  6. Use the spudger to lift the motherboard from the phone. Use the spudger to lift the motherboard from the phone. Use the spudger to lift the motherboard from the phone.
    • Use the spudger to lift the motherboard from the phone.

  7. Caution: The circuit board is connected via ribbon to the phone. Do not break this connection. Note: The circuit board is attached by clips on both sides of the board. Detach each clip before removing the motherboard from the phone. Use the spudger to detach the circuit board from the phone.
    • Caution: The circuit board is connected via ribbon to the phone. Do not break this connection.

    • Note: The circuit board is attached by clips on both sides of the board. Detach each clip before removing the motherboard from the phone.

    • Use the spudger to detach the circuit board from the phone.

  8. Open the phone to expose the keypad. Use your finger to push the keypad from the front towards the circuit board. Remove the keypad from the phone.
    • Open the phone to expose the keypad.

    • Use your finger to push the keypad from the front towards the circuit board.

    • Remove the keypad from the phone.

结论

To reassemble your device, follow these instructions in reverse order.

Braden Burk

于2012年01月22日注册

1 信誉积分

创作了5篇指南

团队

Cal Poly, Team 3-29, Amido Winter 2012 Cal Poly, Team 3-29, Amido Winter 2012 的会员

CPSU-AMIDO-W12S3G29

4 名成员

创作了14篇指南

浏览统计数据:

过去的24小时: 0

过去的7天: 0

过去的30天: 0

总计 638