Kyvol Cybovac L20 Brush Roller Motor Replacement

简介

If your Kyvol Cybovac L20 is struggling to vacuum the floor effectively, spin the brush roll, or clean, use this guide to replace the main motor.

This main motor is responsible for rotating the main brush roll. This component not working correctly will lead to dirt being left on the ground. Before using this guide, make sure to take out the brush and ensure that it is placed properly in its position as well as that it is clean and not clogged up.

你所需要的

步骤 1 Battery

Kyvol Cybovac L20 Brush Roller Motor Replacement, Battery: 步骤 1 中的图像 1，1

Begin with the device laying on a flat surface with the power button facing up.

翻译

步骤 2

Remove both of the side brushes.

翻译

步骤 3

Use a Phillips #1 screwdriver to remove two 1 mm screws that secure the panel.
Remove the battery panel.

翻译

步骤 4

Slightly lift the battery out of the compartment.
Disconnect the battery connector.
Completely remove the battery.

翻译

步骤 5 Brush Roller Motor

Kyvol Cybovac L20 Brush Roller Motor Replacement, Brush Roller Motor: 步骤 5 中的图像 1，1

Remove the dust bin from the underside of the unit.

翻译

步骤 6

Press in on the two clips holding the brush roller housing in place and remove the brush roller cover.

翻译

步骤 7

Remove the brush roller.

翻译

步骤 8

Remove the eight 12 mm Phillips screws from the underside of the unit.

翻译

步骤 9

Kyvol Cybovac L20 Brush Roller Motor Replacement: 步骤 9 中的图像 3，3

Slightly lift the bottom of the unit from the top housing, with care not to pull or damage the connections between the top case and motherboard.
Disconnect the three motherboard connections that connect the top case and motherboard.

翻译