跳转到主内容

Kurio Xtreme Camera Replacement

你所需要的

  1. Kurio Xtreme Camera Replacement, Back Panel: 步骤 1 中的图像 1,1
    • Remove the rubber case by beginning to peel from one of the top corners and continue peeling until the cover is completely removed.

  2. Kurio Xtreme Camera Replacement: 步骤 2 中的图像 1,2 Kurio Xtreme Camera Replacement: 步骤 2 中的图像 2,2
    • Unscrew the four 4 mm black screws using a Phillips #000 screw driver.

    • There are two screws on each side of the device (four total).

  3. Kurio Xtreme Camera Replacement: 步骤 3 中的图像 1,3 Kurio Xtreme Camera Replacement: 步骤 3 中的图像 2,3 Kurio Xtreme Camera Replacement: 步骤 3 中的图像 3,3
    • Insert the plastic opening tool in between the edges of the blue front casing and black back casing.

    • Slide the plastic opening tool around the perimeter of the device. This may require that you repeatedly run the opening tool up and down the edges of the device.

    • Be sure not to break any of the plastic clamps along the edges of the device when removing the back cover.

    • Carefully lift the back panel off of the rest of the device.

  4. Kurio Xtreme Camera Replacement, Camera: 步骤 4 中的图像 1,1
    • Remove the flat-topped connector that connects the cameras to the motherboard by using the plastic opening tool to pry up on each side.

  5. Kurio Xtreme Camera Replacement: 步骤 5 中的图像 1,3 Kurio Xtreme Camera Replacement: 步骤 5 中的图像 2,3 Kurio Xtreme Camera Replacement: 步骤 5 中的图像 3,3
    • Remove the smaller, front facing camera by lifting up on the attached ribbon cable.

    • Remove the larger, rear facing camera by lifting up on the attached ribbon cable.

结论

To reassemble your device, follow these instructions in reverse order.

另外一个人完成了本指南。

Mallory Myers

于09/22/15注册

1,190 声望

创作了7篇指南

团队

Baylor, Team 6-10, Williams Fall 2015 Baylor, Team 6-10, Williams Fall 2015 的会员

BU-WILLIAMS-F15S6G10

3 名成员

创作了14篇指南

0条评论

添加评论

浏览统计数据:

过去 24 小时: 0

过去 7 天: 0

过去 30 天: 0

总计 171