跳转到主内容

简介

This guide will show you how to replace the trigger of the Koosh Vortex Tornado.

配件

没有特定配件。

  1. Remove the fourteen 150 mm Phillips #1 screws on the side of the body.
    • Remove the fourteen 150 mm Phillips #1 screws on the side of the body.

  2. Pull the shells apart to show the inside of the gun.  Set the left shell aside.
    • Pull the shells apart to show the inside of the gun. Set the left shell aside.

  3. Using a spudger, unhook the barrel shield's spring from the base of the gun.
    • Using a spudger, unhook the barrel shield's spring from the base of the gun.

  4. Slide the barrel shield and shield slide off of the gun and set aside.
    • Slide the barrel shield and shield slide off of the gun and set aside.

  5. Slide of the rubber ring and set aside.
    • Slide of the rubber ring and set aside.

  6. Lift the yellow trigger from its pin and set aside.
    • Lift the yellow trigger from its pin and set aside.

结论

To reassemble your device, follow these instructions in reverse order.

Lingbin Meng

于2016年02月16日注册

201 信誉积分

创作了2篇指南

团队

IUPUI, Team 2-4, Harley Spring 2016 IUPUI, Team 2-4, Harley Spring 2016 的会员

IUPUI-HARLEY-S16S2G4

4 名成员

创作了3篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 0

过去的30天: 0

总计 56