简介

Back Cover Teardown guide must be used first to get inside the camera. Later, soldering guides will be used.

  1. Remove the two 6.2mm Phillips screws on both sides of camera's back cover.
    • Remove the two 6.2mm Phillips screws on both sides of camera's back cover.

    添加评论

  2. Turn camera so the bottom is facing up and the front is facing away.
    • Turn camera so the bottom is facing up and the front is facing away.

    • Remove the two 6.2mm Phillips screws on the bottom back cover of the camera.

    • Back cover is now unscrewed an can be removed.

    添加评论

  3. 传播 Fixmas 欢乐
    Get $12 off your purchase of $50 or more with code FIXMAS12
    传播 Fixmas 欢乐
    Get $12 off your purchase of $50 or more with code FIXMAS12
    • Have the back of the camera facing up.

    • Unscrew the 6.2mm Phillips screw next to the viewfinder.

    • The back cover is now unscrewed. Lift up and pull the cover off evenly.

    添加评论

    • The capacitor is located at the bottom center of the camera.

    添加评论

    • Desolder the two connections at the top of the flash capacitor.

    • If unfamiliar with soldering, refer to the guide 如何焊接和脱焊

    添加评论

结论

To reassemble your device, follow these instructions in reverse order.

Michelle

于2011年04月04日注册

86 信誉积分

创作了5篇指南

团队

Cal Poly, Team 25-28, Garner Spring 2011 Cal Poly, Team 25-28, Garner Spring 2011 的会员

CPSU-GARNER-S11S25G28

4 名成员

创作了6篇指南

添加评论

浏览统计数据:

过去的24小时: 1

过去的7天: 2

过去的30天: 6

总计 1,773