跳转到主内容

简介

Removing the back cover of your Kodak PixPro AZ251 gives you access to the camera's LCD screen and motherboard. This guide will instruct you on how to remove the back cover of your Kodak PixPro AZ251.

  1. Slide switch to open lock position. Slide switch to open lock position.
    • Slide switch to open lock position.

  2. Press down on the battery cover and slide outwards to open. Press down on the battery cover and slide outwards to open.
    • Press down on the battery cover and slide outwards to open.

  3. Remove the batteries.
    • Remove the batteries.

  4. iPhone X Fix Kits

    Warranty up? No worries, we’ve got the fix.

    现在开始购物

    iPhone X Fix Kits

    Warranty up? No worries, we’ve got the fix.

    现在开始购物
  5. Remove a total of four 5mm JIS #000 screws from around the camera: Two screws from the right side. Two screws from the left side.
    • Remove a total of four 5mm JIS #000 screws from around the camera:

    • Two screws from the right side.

    • Two screws from the left side.

  6. Remove the single 5mm Phillips #00 screw from the bottom.
    • Remove the single 5mm Phillips #00 screw from the bottom.

  7. Open the flash module. Remove the two 6mm JIS #00 screws found inside of the flash housing.
    • Open the flash module.

    • Remove the two 6mm JIS #00 screws found inside of the flash housing.

  8. Use a plastic opening tool to pry apart both halves of the camera. Remove the back panel. Remove the back panel.
    • Use a plastic opening tool to pry apart both halves of the camera.

    • Remove the back panel.

结论

To reassemble your device, follow these instructions in reverse order.

Luiza Oliveira

于2018年02月22日注册

205 信誉积分

创作了2篇指南

团队

USF Tampa, Team S1-G1, Cagle Spring 2018 USF Tampa, Team S1-G1, Cagle Spring 2018 的会员

USFT-CAGLE-S18S1G1

4 名成员

创作了7篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 0

过去的30天: 2

总计 134