步骤 1 Battery

• Slide the grey plastic cover laterally off the back of the device.
翻译
添加一条评论
添加一条评论
添加评论
1024
取消 发帖评论
步骤 2



• Use a plastic opening tool to lift the battery on the side closest to the edge of the device.
• Unplug the battery from the device by pinching the white connector and pulling.
• Do not yank the battery or try to disconnect the battery by pulling the wires.
翻译
1条评论
添加一条评论
添加评论
1024
取消 发帖评论
步骤 3 SD Card Reader
• Unscrew eight (8) Phillips #00 screws (3 mm).
翻译
添加一条评论
添加一条评论
添加评论
1024
取消 发帖评论
步骤 4
• Start at one side of the device. Use a plastic opening tool to separate the casing of the device. Slowly work your way around the entire device.
• Avoid prying between the buttons and the device. This could cause damage to the buttons.
翻译
添加一条评论
添加一条评论
添加评论
1024
取消 发帖评论
步骤 5
• Unscrew the two (2) Phillips #00 screws (3 mm) which fasten the metal casing shield.
• Slowly remove the metal casing shield by lifting it and carefully peeling up the tape.
翻译
添加一条评论
添加一条评论
添加评论
1024
取消 发帖评论
步骤 6
• Remove the four (4) Phillips #00 screws (3 mm) which fasten the SD Card Reader.
翻译
添加一条评论
添加一条评论
添加评论
1024
取消 发帖评论
步骤 7
• Lift the flap attaching the blue and white ribbon cable to the motherboard by lifting it vertically with a spudger.
• The flap is connected via a hinge. Once you lift the flap, it will stay up and the cable will be lose. Remember to snap it back down during reassembly.
• Carefully lift the SD Card Reader vertically from the motherboard.
翻译
添加一条评论
添加一条评论
添加评论
1024
取消 发帖评论

嵌入本指南

选择一个尺寸并复制下面的代码，将本指南作为一个小插件嵌入到你的网站/论坛中。

<iframe id="dozuki-embed-15395" src="https://zh.ifixit.com/Guide/embed/15395/full" width="800" allowfullscreen frameborder="0"></iframe> <script>window.addEventListener("message",function(a){var b=document.getElementById("dozuki-embed-15395"),c=a.data[0],d=a.data[1];switch(c){case"setHeight":b.style.height=d+"px"}},!1);</script> <iframe src="https://zh.ifixit.com/Guide/embed/15395" width="800" height="584" allowfullscreen frameborder="0"></iframe>

预览