跳转到主内容
  1. Remove both 8.0 mm Phillips #1 screws, one for each wheel.
    • Remove both 8.0 mm Phillips #1 screws, one for each wheel.

  2. Remove the wheels by pulling them away from the RC car.
    • Remove the wheels by pulling them away from the RC car.

  3. Make note of where each driving gear cover is placed. They only go in one way.
    • Make note of where each driving gear cover is placed. They only go in one way.

    • Remove the eight 8.0mm Phillips #00 screws, two screws for each wheel.

  4. Pry open the two gear covers on both sides.
    • Pry open the two gear covers on both sides.

  5. Pull the driving gears off the axles by sliding them off the axles and exposing both axles.
    • Pull the driving gears off the axles by sliding them off the axles and exposing both axles.

  6. Slide both axles from the internal axles guides within the car.
    • Slide both axles from the internal axles guides within the car.

    • Reverse the steps to replace the axles.

结论

To reassemble your device, follow these instructions in reverse order.

Rusbell Gonzalez

于2014年09月17日注册

219 信誉积分

创作了5篇指南

团队

USF Tampa, Team 1-2, Hickman Fall 2014 USF Tampa, Team 1-2, Hickman Fall 2014 的会员

USFT-HICKMAN-F14S1G2

3 名成员

创作了7篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 0

过去的30天: 1

总计 155