简介

This guide give instructions on how to locate the keypad for removal and/or repair.

Flip over the phone and then slide down the back cover with your thumb.
  • Flip over the phone and then slide down the back cover with your thumb.

添加评论

Lever out the battery from the phone using your thumb.
  • Lever out the battery from the phone using your thumb.

添加评论

  • Use a plastic opening tool to pry out the two tabs on the top corners of the battery compartment.

添加评论

  • Gently pull off hinge cap piece from the the top of the phone.

添加评论

  • Using a T6 Torx Screwdriver, remove the four 7.62mm screws around the corners of the battery compartment.

添加评论

  • Open the phone and turn it on its side.

  • Using a plastic opening tool, run along the seam located around the sides of the phone to pop the clips holding the casing to the frame.

添加评论

  • Using your hand, gently pull of the back panel from the bottom half of the phone.

添加评论

  • Close the phone and place it on a flat surface.

  • Using a plastic opening tool or your finger, lift up the motherboard from the bottom casing.

  • Be careful when pulling up the board, as there is still a ribbon cable attached to the back of the board.

添加评论

  • On the underside of the motherboard, find the ribbon cable that attaches the board to the rest of the phone.

  • Using a plastic opening tool, slowly detach the ribbon cable connector, then pull the motherboard away from the frame.

添加评论

  • Once the motherboard is moved out of the way, pry out the keypad with a plastic opening tool

添加评论

结论

To reassemble your device, follow these instructions in reverse order.

另外一个人完成了本指南。

Andrew

于2010年10月04日注册

358 信誉积分

创作了4篇指南

团队

Cal Poly, Team 4-46, Amido Fall 2010 Cal Poly, Team 4-46, Amido Fall 2010 的会员

CPSU-AMIDO-F10S4G46

4 名成员

创作了14篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 0

过去的30天: 3

总计 2,101