Jumper EZbook S5 Touchpad Replacement

简介

There are different techniques to replace an Intel Celeron Jumper Laptop Touchpad. To complete this guide, you will absolutely need two screwdrivers which are (1) a screwdriver and (2) a flat-blade screwdriver. To replace a touchpad, you will also need a new touchpad.

Reminder: Your new touchpad should be the correct size corresponding to the size of your laptop.

你所需要的

步骤 1 Touchpad

Jumper EZbook S5 Touchpad Replacement, Touchpad: 步骤 1 中的图像 1，2

Jumper EZbook S5 Touchpad Replacement, Touchpad: 步骤 1 中的图像 2，2

Place the laptop so the bottom is facing upwards.
Remove the two 8 mm screws on the back of the laptop using a T3 Torx screwdriver.
Remove the three 5 mm screws on the back of the laptop using a T3 Torx screwdriver.
Remove the six 4 mm screws on the back of the laptop using a T3 Torx screwdriver.
Remove the single 3 mm base screw inside the battery case using a T3 Torx screwdriver.

编辑

步骤 2

Jumper EZbook S5 Touchpad Replacement: 步骤 2 中的图像 3，3

Detach the battery case using the flat end of a spudger.

编辑

步骤 3

Jumper EZbook S5 Touchpad Replacement: 步骤 3 中的图像 3，3

Pry apart the bottom cover of the laptop using the flat end of a spudger.

编辑

步骤 4

Jumper EZbook S5 Touchpad Replacement: 步骤 4 中的图像 3，3

Remove the four 4 mm screws from the battery using a T3 Torx screwdriver.

编辑

步骤 5

Jumper EZbook S5 Touchpad Replacement: 步骤 5 中的图像 3，3

Flip the battery to the opposite side of the touchpad.

编辑

步骤 6

Jumper EZbook S5 Touchpad Replacement: 步骤 6 中的图像 3，3

Detach the tape on the left side of the touchpad shown in the first two images.
Use a heat gun or a hair dryer to melt the glue quickly.

编辑

步骤 7

Jumper EZbook S5 Touchpad Replacement: 步骤 7 中的图像 3，3

Detach the tape on the right side of the touchpad shown in all three images.
Use a hair dryer or a heat gun to soften the glue.

编辑

步骤 8

Jumper EZbook S5 Touchpad Replacement: 步骤 8 中的图像 3，3

Use a spudger to detach the touchpad from the top case.
The touchpad is attached to the top case with glue. Use a hair dryer or a heat gun to soften the glue.
Be patient. Step 8 can take up to 8 hours if you work by yourself.
Don't aim the heat gun or the hair dryer anywhere other than the top case.