Jumper Angelsounds JPD-100S Volume Knob Replacement

简介

You will need knowledge of how to use a soldering iron station. For more information regarding soldering visit: Soldering Skills During the replacement of the volume knob, you will unscrew the knob from the motherboard. After removing the screw you will then need to unsolder the rest of the knob from the motherboard.

你所需要的

步骤 1 Motherboard

Jumper Angelsounds JPD-100S Volume Knob Replacement, Motherboard: 步骤 1 中的图像 1，1

Access the battery compartment
Remove the battery compartment lid and set it aside.
Disconnect the battery and set it aside.

翻译

步骤 2

Puncture the sticker in the battery compartment with a spudger to access the screw beneath it.

翻译

步骤 3

Remove the 7mm Phillips #1 screw from the battery compartment.
Place the screw in a secure place.

翻译

步骤 4

Begin prying open the device.
Insert a plastic opening tool into the side groove about 2cm from the pink plastic component and pry open one side of the device.
Once the side is separated, leave the opening tool inside to prevent the two sides from closing.

翻译

步骤 5

Insert another plastic opening tool into the groove opposite to the side of the tool already inserted.
Create separation on that side until the white plastic component comes off entirely.
Place the white plastic component in a secure place.

翻译

步骤 6

With your hand, remove the pink component.

翻译

步骤 7

Remove the 7mm Phillips #1 screw in the middle of the motherboard.

翻译

步骤 8 Volume Knob

Jumper Angelsounds JPD-100S Volume Knob Replacement, Volume Knob: 步骤 8 中的图像 1，2

Jumper Angelsounds JPD-100S Volume Knob Replacement, Volume Knob: 步骤 8 中的图像 2，2

在这个步骤中使用的工具：

Tweezers

$4.99

购买

Remove the white glue on the volume knob by peeling it off or gently using tweezers to pull it out.
Allow approximately 10 minutes for the soldering station to heat up before using.