跳转到主内容

简介

This guide will show you how to replace a faulty lens unit for this camera.

  1. With the H2.0 bit screwdriver, remove the two screws on the yellow waterproof cover
    • With the H2.0 bit screwdriver, remove the two screws on the yellow waterproof cover

  2. Apply a plastic opening tool to each of the corners and gently remove the casing
    • Apply a plastic opening tool to each of the corners and gently remove the casing

    • The front casing is held down by adhesive and may require additional work to remove

    • Apply just enough force to undo the inner latches to make sure not to damage the waterproof seal

  3. Remove the five silver screws from the inner casing using the PH00 screwdriver bit
    • Remove the five silver screws from the inner casing using the PH00 screwdriver bit

  4. Remove the six screws from the edge of the clear inner casing with the PH00 screwdriver bit
    • Remove the six screws from the edge of the clear inner casing with the PH00 screwdriver bit

    • These screws are very small and easy to strip so apply consistent pressure when removing them

  5. Macbook 电池维修套装

    起价 $69.99

    Buy Now

    Macbook 电池维修套装

    起价 $69.99

    Buy Now
  6. Pry off back outer casing using the black spudger or the blue prying tools
    • Pry off back outer casing using the black spudger or the blue prying tools

  7. Carefully remove the screen from the silver casing using a prying tool or the black spudger
    • Carefully remove the screen from the silver casing using a prying tool or the black spudger

    • There is adhesive in the center of the screen, be sure not to bend it when applying pressure

  8. Using the poker end of the spudger push gently on the black pegs holding the orange tape in place
    • Using the poker end of the spudger push gently on the black pegs holding the orange tape in place

    • Screen and orange tape should slip out as a whole

  9. Remove three screws holding the silver screen casing to the motherboard using the PH00 bit screwdriver
    • Remove three screws holding the silver screen casing to the motherboard using the PH00 bit screwdriver

  10. Remove three screws holding the motherboard into the casing using the PH00 bit screwdriver
    • Remove three screws holding the motherboard into the casing using the PH00 bit screwdriver

  11. Gently lift the corner of the motherboard out
    • Gently lift the corner of the motherboard out

    • Everything should come out as one component free of the casing

  12. Remove the two screws holding the lens assembly to the motherboard using the PH00 bit screwdriver
    • Remove the two screws holding the lens assembly to the motherboard using the PH00 bit screwdriver

  13. Remove the soldering on the 3 wires that are connected to the lens unit
    • Remove the soldering on the 3 wires that are connected to the lens unit

结论

To reassemble your device, follow these instructions in reverse order.

另外一个人完成了本指南。

Jack Schlandt

于2016年02月08日注册

197 信誉积分

撰写一个指南

团队

USF Tampa, Team 6-6, Eyestone Spring 2016 USF Tampa, Team 6-6, Eyestone Spring 2016 的会员

USFT-EYESTONE-S16S6G6

3 名成员

创作了5篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 0

过去的30天: 0

总计 72