跳转到主内容

修复你的物品

维修的权力

商店

  1. Slide the “Open” tab on the top of the device. This will allow you to open the device.
    • Slide the “Open” tab on the top of the device.

    • This will allow you to open the device.

  2. Remove the six Phillips #00 screws from the screen casing.
    • Remove the six Phillips #00 screws from the screen casing.

    • To access two of the screws, first remove 2 small, flat rubber circles from the corners of the screen casing. Use a spudger if necessary.

  3. Remove the two screws from the hinge that holds together the screen casing and the disk panel.
    • Remove the two screws from the hinge that holds together the screen casing and the disk panel.

    • Abruptly opening the device too wide will break the hinge. To fully access the hinge screws, firmly but gently open the device wider.

  4. Insert the plastic opening tool into the rectangular holes and pry open in order to access the interior of the screen casing.
    • Insert the plastic opening tool into the rectangular holes and pry open in order to access the interior of the screen casing.

    • Remove the four screws and corresponding washers from the edges of the screen.

    • Use a plastic opening tool to prop open if necessary.

  5. Remove the eight screws from the green motherboard.
    • Remove the eight screws from the green motherboard.

  6. Unplug the red wires from the motherboard by gently pulling them off.
    • Unplug the red wires from the motherboard by gently pulling them off.

    • Then remove the screen.

  7. Set the new screen in place.
    • Set the new screen in place.

结论

To reassemble your device, follow these instructions in reverse order.

Jen Rodas

于2015年09月30日注册

1 信誉积分

撰写一个指南

团队

Ohio State, Team 2-5, Garvin Fall 2015 Ohio State, Team 2-5, Garvin Fall 2015 的会员

OSU-GARVIN-F15S2G5

3 名成员

创作了1篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 0

过去的30天: 0

总计 380