简介

The Insignia 2-in-1 Handheld vacuum button may get jammed or the electrical components can stop working. In either case, this guide can show you how to fix or replace the power button.

配件

无需配件。

  1. Push down the black button to release the dust cup. Pull the dust cup up and away from handheld portion to remove.
    • Push down the black button to release the dust cup.

    • Pull the dust cup up and away from handheld portion to remove.

  2. Remove the five 12.0 mm screws on the back of the handheld portion using the Phillips #2 screwdriver. Lift the silver cover off of the black body of the handheld portion to expose the battery and wiring. Lift the silver cover off of the black body of the handheld portion to expose the battery and wiring.
    • Remove the five 12.0 mm screws on the back of the handheld portion using the Phillips #2 screwdriver.

    • Lift the silver cover off of the black body of the handheld portion to expose the battery and wiring.

  3. Pull apart the red and black wires. Do so for all of the wires. (Red x1, Black x2)
    • Pull apart the red and black wires.

    • Do so for all of the wires. (Red x1, Black x2)

  4. 所有超过US$100或包含 Pro Tech工具包的订单免费送货!

    浏览我们的商店
  5. Remove the tape holding the battery to the black housing.
    • Remove the tape holding the battery to the black housing.

    • Slide the entire battery bundle out.

  6. Remove motor and impeller housing to gain access to power button.
    • Remove motor and impeller housing to gain access to power button.

  7. Pry upwards on the retaining clip with black plastic spudger and pull to remove the 5 pin connector. Pry upwards on the retaining clip with black plastic spudger and pull to remove the 5 pin connector.
    • Pry upwards on the retaining clip with black plastic spudger and pull to remove the 5 pin connector.

  8. Remove the two 10mm  Philips #2 screws holding the brown printed circuit board to the vacuum. Remove brown printed circuit board.
    • Remove the two 10mm Philips #2 screws holding the brown printed circuit board to the vacuum.

    • Remove brown printed circuit board.

    • Pull up on clear plastic power button assembly to remove.

结论

To reassemble your device, follow these instructions in reverse order.

Thibaut Pillot

于2018年02月15日注册

428 信誉积分

创作了5篇指南

团队

USF Tampa, Team S16-G3, Boczar Spring 2018 USF Tampa, Team S16-G3, Boczar Spring 2018 的会员

USFT-BOCZAR-S18S16G3

4 名成员

创作了6篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 0

过去的30天: 1

总计 75