修复你的物品 社区 商店

Insignia NS-HD01A Battery Replacement

简介

This guide will show you how to remove the back cover and replace the battery in the radio. There will be several small screws and rubber covers so make sure you have a container to keep them in so that they are not lost.

你所需要的

  1. Insignia NS-HD01A Battery Replacement, Battery: 步骤 1 中的图像 1，1

    • Remove the rubber screw caps using the pointed tip of the Spudger.

    编辑

  2. Insignia NS-HD01A Battery Replacement: 步骤 2 中的图像 1，1

    • Remove the four 6.0 mm Phillips screws located below the rubber caps using the PH00 bit installed in the driver.

    编辑

  4. Insignia NS-HD01A Battery Replacement: 步骤 3 中的图像 1，2 Insignia NS-HD01A Battery Replacement: 步骤 3 中的图像 2，2

    • Use the plastic opening tool to pry open the back cover.

    • Slide the tool around the sides of the radio to gradually pry the back cover off. Do not remove the cover completely as there is still a cable connecting it to radio.

    编辑

  5. Insignia NS-HD01A Battery Replacement: 步骤 4 中的图像 1，3 Insignia NS-HD01A Battery Replacement: 步骤 4 中的图像 2，3 Insignia NS-HD01A Battery Replacement: 步骤 4 中的图像 3，3

    • Use the blunt tweezers to unplug the battery cable from the PCB board. Grab the battery cable plug from the sides.

    编辑

  6. Insignia NS-HD01A Battery Replacement: 步骤 5 中的图像 1，2 Insignia NS-HD01A Battery Replacement: 步骤 5 中的图像 2，2

    • Use the flat side of the Spudger to pry the battery out of the back cover.

    • Insert the replacement battery into the back cover.

    • Reassemble the radio, making sure to reconnect the battery cable.

    编辑
结论

To reassemble your device, follow these instructions in reverse order.

2等其他人完成本指南。

作者

与3其他贡献者

Joel Najmon

于10/08/16注册

152 声望

撰写一个指南

徽章: 4

+1个徽章

团队

IUPUI, Team 2-2, Wilson Fall 2016 IUPUI, Team 2-2, Wilson Fall 2016 的会员

IUPUI-WILSON-F16S2G2

5 名成员

创作了1篇指南

0条评论

添加评论

浏览统计数据:

过去 24 小时： 0

过去 7 天： 2

过去 30 天： 9

总计 1,022