简介

This guide will show the required steps to replace the ice tray on the Insignia Ice Maker.

  1. Remove the 6 screws holding the rear casing on.
    • Remove the 6 screws holding the rear casing on.

    • Remove the rear casing

    添加评论

  2. Remove the 4 screws holding the Ice Tray to the body of the Ice Maker.
    • Remove the 4 screws holding the Ice Tray to the body of the Ice Maker.

    添加评论

    • Remove the 4 screws holding the Ice Tray from the top.

    添加评论

    • Lift the Water Pump out of the way

    添加评论

    • Remove the final 2 screws.

    添加评论

    • Remove the plastic cover from the circuit board by pressing the lever on the side. A pry tool may be required.

    • Disconnect the water tray cord.

    添加评论

结论

To reassemble your device, follow these instructions in reverse order.

Evan Taylor

于2018年01月18日注册

544 信誉积分

创作了5篇指南

团队

Cal Poly, Team S21-G3, Banghart Winter 2018 Cal Poly, Team S21-G3, Banghart Winter 2018 的会员

CPSU-BANGHART-W18S21G3

2 名成员

创作了5篇指南

添加评论

浏览统计数据:

过去的24小时: 1

过去的7天: 1

过去的30天: 10

总计 100