跳转到主内容

简介

This guide will show how to remove and replace the RAM of the IBM Thinkpad T60. Remember to always power down the computer before attempting any installation/removal of any hardware components. Be sure to remove the AC adapter and all cables from the computer. If the computer has been on, wait several minutes before beginning the procedure to ensure all parts have cooled down.

  1. Turn the computer over to see the small tab on the battery located near the top of the Thinkpad.
    • Turn the computer over to see the small tab on the battery located near the top of the Thinkpad.

    • Use your finger to slide the tab to the right to unlock the battery.

  2. Once the tab is in the unlocked position (far right), pull the battery outwards away from the Thinkpad. The battery is now disconnected.
    • Once the tab is in the unlocked position (far right), pull the battery outwards away from the Thinkpad.

    • The battery is now disconnected.

  3. Using a #0 Phillips screwdriver, remove the four 17.0 mm screws. Using a #0 Phillips screwdriver, remove the four 17.0 mm screws.
    • Using a #0 Phillips screwdriver, remove the four 17.0 mm screws.

  4. iPhone 电池维修工具包

    只要 $29.99

    Buy Now

    iPhone 电池维修工具包

    只要 $29.99

    Buy Now
  5. Turn the computer back over, so the keyboard is facing upwards.
    • Turn the computer back over, so the keyboard is facing upwards.

    • Open the display to access the palm rest. Apply pressure to the sides of the palm rest so that it bends upwards in the middle. Gently lift away from the computer.

  6. Slightly lift the palm rest away from the computer. The touchpad's data cable connects the palm rest to the base unit. BE CAREUL!
    • Slightly lift the palm rest away from the computer.

    • The touchpad's data cable connects the palm rest to the base unit. BE CAREUL!

    • Detach the connector by pulling upwards on the white tab.

  7. Press out the two tabs on either side of the card at the same time. The memory card will slide upwards at a 20 degree angle.
    • Press out the two tabs on either side of the card at the same time.

    • The memory card will slide upwards at a 20 degree angle.

  8. Remove the memory card from the slot by pulling perpendicular to the slot.
    • Remove the memory card from the slot by pulling perpendicular to the slot.

结论

To reassemble your device, follow these instructions in reverse order.

12等其他人完成本指南。

Cody Kratochvil

于2013年01月11日注册

424 信誉积分

创作了5篇指南

团队

Cal Poly, Team 7-9, Maness Winter 2013 Cal Poly, Team 7-9, Maness Winter 2013 的会员

CPSU-MANESS-W13S7G9

4 名成员

创作了16篇指南

添加评论

浏览统计数据:

过去的24小时: 1

过去的7天: 10

过去的30天: 57

总计 11,481