简介

Use this guide to replace the motherboard in your Huawei P10 Lite smartphone.

Insert the tip of an opening pick between the back cover and the mid frame and slide it around the phone, to cut the adhesive.
  • Insert the tip of an opening pick between the back cover and the mid frame and slide it around the phone, to cut the adhesive.

添加评论

After you cut the adhesive on every edge, twist your opening pick, to separate the rear cover from the phone.
  • After you cut the adhesive on every edge, twist your opening pick, to separate the rear cover from the phone.

  • Flip the rear cover over to the right side of the phone.

添加评论

  • Use tweezers to remove the liquid indicator sticker.

添加评论

  • Remove the two Phillips #00 screws.

  • Remove the four 2.5 mm Phillips #00 screws.

添加评论

  • Use tweezers to remove the mainboard shield.

  • Use the flat end of a spudger to disconnect the finger print sensor flex cable.

    • When reassembling apply new adhesive where it is necessary.

WElchen Klebstoff soll man verwenden?

josef navratil - 回复

Welchen Klebstoff soll man verwenden?

josef navratil - 回复

Hallo Josef,

sollte bei deinem Ersatzteil kein Klebstoff oder Klebeband dabei gewesen sein, kannst du dünne Streifen Doppelseitiges Klebeband verwenden. Es gibt für das Huawei P10 Lite auch schon zugeschnittene Klebestreifen zu erwerben, hierbei gilt aber je nach Händler Rezessionen zu lesen, ob die Klebestreifen auch wirklich halten.

Dominik Schnabelrauch -

  • Remove the SIM card tray before you perform any further actions..

添加评论

  • Remove the three Phillips #000 screws.

  • Use tweezers to remove the two metal shields which cover the flex cables on the mainboard.

添加评论

  • Use the flat end of a spudger to disconnect the volume and power button, the display and the main flex cable.

添加评论

  • Disconnect the battery flex cable with a spudger.

  • Unplug the antenna cable with tweezers.

添加评论

  • Disconnect the headphone jack flex cable with the flat end of a spudger.

  • Use an opening pick to pry out the motherboard until you can get a good grip.

  • Both camera are still attached to the motherboard. Don't damage them while you remove it.

  • Remove the motherboard.

    • If you want to replace your motherboard you need to disconnect both cameras and transfer them to your spare part.

添加评论

结论

To reassemble your device, follow these instructions in reverse order. When reassembling your phone apply new adhesive where it is necessary.

2等其他人完成本指南。

Dominik Schnabelrauch

于2016年11月23日注册

17,119 信誉积分

创作了90篇指南

团队

iFixit iFixit 的会员

Community

107 名成员

创作了6,495篇指南

添加评论

浏览统计数据:

过去的24小时: 6

过去的7天: 89

过去的30天: 385

总计 2,084