跳转到主内容

简介

Use this guide to replace the back cover of your Huawei P10 smartphone.

  1. Switch off your phone. Remove the two Pentalobe P2 screws at the bottom. Remove the SIM card tray.
    • Switch off your phone.

    • Remove the two Pentalobe P2 screws at the bottom.

    • Remove the SIM card tray.

  2. Insert a plastic opening tool between the display and the case starting at the bottom area of your phone. Carefully pry the display with its parts out of the case. Getting the prying tool in  will require some effort, be careful not to slide the tool too much or you might slightly damage the housing.
    • Insert a plastic opening tool between the display and the case starting at the bottom area of your phone.

    • Carefully pry the display with its parts out of the case.

    • Getting the prying tool in will require some effort, be careful not to slide the tool too much or you might slightly damage the housing.

    • After you pried out the bottom end, use the opening tool to open the clamps on both sides.

  3. Don't open the phone all the way, yet. The cable for the standby and volume buttons is still connected to the back cover. Swing open the phone backwards.
    • Don't open the phone all the way, yet. The cable for the standby and volume buttons is still connected to the back cover.

    • Swing open the phone backwards.

    • Use a spudger to disconnect the power- and volume button flex cable.

结论

To reassemble your device, follow these instructions in reverse order.

5等其他人完成本指南。

Dominik Schnabelrauch

于2016年11月23日注册

94,423 信誉积分

创作了387篇指南

团队

iFixit iFixit 的会员

Community

137 名成员

创作了16,428篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 15

过去的30天: 60

总计 6,208