简介

Use this guide to replace the back cover of your Huawei Mate 10 Pro smartphone.

  1. Before disassembling your phone, discharge the battery below 25%. A charged lithium-ion battery can catch fire and/or explode if accidentally punctured.
    • Before disassembling your phone, discharge the battery below 25%. A charged lithium-ion battery can catch fire and/or explode if accidentally punctured.

    • Switch off your phone.

    • Remove the SIM card tray.

    • Use an iOpener to loosen the adhesive beneath the back cover.

    添加评论

  2. Lift up the back cover with a suction cup until you can insert the flat end of a halberd spudger.
    • Lift up the back cover with a suction cup until you can insert the flat end of a halberd spudger.

    • Use the halberd spudger to cut the adhesive beneath the display on all sides of the phone.

      • Use opening picks to avoid the adhesive from sticking to the back cover again while cutting the adhesive on all sides.

    添加评论

    • Don't remove the back cover all the way, yet. The fingerprint sensor cable is still connected to motherboard.

    • Flip the back cover over to the side.

    • Remove the Phillips #00 screw which holds down the metal shield, sitting on top of the connection of the fingerprint sensor cable.

    添加评论

    • Use tweezers to remove the metal shield covering the connector of the fingerprint sensor.

    • Disconnect the fingerprint sensor cable with a spudger.

    • When reassembling your phone apply new adhesive where it is necessary.

    添加评论

结论

To reassemble your device, follow these instructions in reverse order.

Dominik Schnabelrauch

于2016年11月23日注册

20,350 信誉积分

创作了108篇指南

团队

iFixit iFixit 的会员

Community

114 名成员

创作了6,999篇指南

Where can I buy the back part of the phone. Email me at brownpridebandit@gmail.com

Luis Liberato - 回复

添加评论

浏览统计数据:

过去的24小时: 5

过去的7天: 38

过去的30天: 206

总计 964