跳转到主内容

简介

If you spin your wheels and they stop right away, your bearings need to be cleaned and lubricated. Get your performance bearings back to performing with this guide. There are 7 quick and easy steps. The process should take about a half hour.

  1. Turn your wrench to the left to remove the wheel nut. Take the wheel off of your trucks by pulling.
    • Turn your wrench to the left to remove the wheel nut.

    • Take the wheel off of your trucks by pulling.

    • Keep all nuts and spacers in separated, designated areas.

    • Wear gloves. You are working with messy materials such as gasoline.

  2. Firmly lever the bearing out using your screwdriver. Do not be overly forceful to avoid scratching the bearing.
    • Firmly lever the bearing out using your screwdriver.

    • Do not be overly forceful to avoid scratching the bearing.

  3. Soak the bearing in a cup with premium gasoline for 5 minutes.
    • Soak the bearing in a cup with premium gasoline for 5 minutes.

    • Soak each bearing separately so none are lost or dented.

  4. Take the bearing out of the gasoline and remove one side of the outside plastic locks by applying pressure on the inner ring and prying up. Make sure you can clearly see and access the ball bearings. Make sure you can clearly see and access the ball bearings.
    • Take the bearing out of the gasoline and remove one side of the outside plastic locks by applying pressure on the inner ring and prying up.

    • Make sure you can clearly see and access the ball bearings.

  5. Use your toothbrush to clean the bearings by using a gentle back and forth scrubbing motion.
    • Use your toothbrush to clean the bearings by using a gentle back and forth scrubbing motion.

    • Rinse the bearing with water and let dry for 5 minutes.

  6. Once dry, pick up your bearings with two fingers and drop 2 drops of skateboard lubricant into the bearing. Spin the bearings immediately to spread the lubricant evenly.
    • Once dry, pick up your bearings with two fingers and drop 2 drops of skateboard lubricant into the bearing.

    • Spin the bearings immediately to spread the lubricant evenly.

  7. Use a paper towel to remove excess lubricant. Replace the plastic guard. Replace the plastic guard.
    • Use a paper towel to remove excess lubricant.

    • Replace the plastic guard.

结论

To reassemble your device, firmly put bearings back into your wheels and tighten them back down onto the trucks.

另外一个人完成了本指南。

Luke Marshall

于2015年04月09日注册

126 信誉积分

撰写一个指南

团队

Cal Poly, Team 30-2, Green Spring 2015 Cal Poly, Team 30-2, Green Spring 2015 的会员

CPSU-GREEN-S15S30G2

4 名成员

创作了3篇指南

添加评论

浏览统计数据:

过去的24小时: 6

过去的7天: 15

过去的30天: 108

总计 2,574