1. Make sure you start with a frame thats straight and square.  I use a table with cleats at 90 degrees to make sure each frame is correct
    • Make sure you start with a frame thats straight and square. I use a table with cleats at 90 degrees to make sure each frame is correct

  2. Get the spline started in one corner by forcing it in with a flat blade screwdriver
    • Get the spline started in one corner by forcing it in with a flat blade screwdriver

  3. 所有超过US$100或包含 Pro Tech工具包的订单免费送货!

    浏览我们的商店
  4. Pre roll the pet screen into the spline groove . Make sure the cloth goes in square and flat. Pull it out and try again if it does not.
    • Pre roll the pet screen into the spline groove . Make sure the cloth goes in square and flat. Pull it out and try again if it does not.

  5. Use a new sharp blade in your utility knife to cut through pet screen
    • Use a new sharp blade in your utility knife to cut through pet screen

  6. Trim off the excess leaving about 2 inches over the frame before rolling  the material in. Leaving too much material hanging will prevent the cloth from laying flat and square.
    • Trim off the excess leaving about 2 inches over the frame before rolling the material in. Leaving too much material hanging will prevent the cloth from laying flat and square.

  7. The finished job should look flat and square, the screen bars should not be bowed in.
    • The finished job should look flat and square, the screen bars should not be bowed in.

结论

To reassemble your device, follow these instructions in reverse order.

Adrian Dunevein

于2018年06月22日注册

133 信誉积分

撰写一个指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 0

过去的30天: 0

总计 7