跳转到主内容

简介

The bottom half of the phone will need to be disassembled, see "replacing logic board" for instructions to remove logic board.

  1. Remove the back panel by pressing up on switch, located at the top on the back of the phone.
    • Remove the back panel by pressing up on switch, located at the top on the back of the phone.

    • You may want to use a plastic opening tool to help pry the back panel off.

  2. Unscrew the four 4.5mm screws located on the back plate.
    • Unscrew the four 4.5mm screws located on the back plate.

  3. Remove the rubber screw cover using your fingernail.
    • Remove the rubber screw cover using your fingernail.

  4. Unscrew the 4.5mm screw located underneath the rubber cover.
    • Unscrew the 4.5mm screw located underneath the rubber cover.

  5. iPhone 电池维修工具包

    只要 $29.99

    Buy Now

    iPhone 电池维修工具包

    只要 $29.99

    Buy Now
  6. Wedge the end of a plastic opening tool into the crack between the back panel and the phone.
    • Wedge the end of a plastic opening tool into the crack between the back panel and the phone.

    • The panel should come off without much effort.

  7. With the back panel removed, the motherboard should be fully exposed.
    • With the back panel removed, the motherboard should be fully exposed.

  8. Remove the camera and volume buttons and place them in a safe spot until reassembly. Remove the camera and volume buttons and place them in a safe spot until reassembly.
    • Remove the camera and volume buttons and place them in a safe spot until reassembly.

  9. Using a plastic opening tool, unplug the ribbon cable connecting the front LCDs to the motherboard. Using a plastic opening tool, unplug the ribbon cable connecting the front LCDs to the motherboard.
    • Using a plastic opening tool, unplug the ribbon cable connecting the front LCDs to the motherboard.

  10. Detach the motherboard by grabbing the edges of it and lifting it straight out of the phone. Detach the motherboard by grabbing the edges of it and lifting it straight out of the phone.
    • Detach the motherboard by grabbing the edges of it and lifting it straight out of the phone.

  11. After removing motherboard, the phone will look like this.
    • After removing motherboard, the phone will look like this.

  12. Grab the corner of the rubber key pad and lift out slowly.
    • Grab the corner of the rubber key pad and lift out slowly.

  13. By using a small standard screwdriver and a fine, thin, soft cloth you can clean in between the keypad to remove dirt and debris. By using a small standard screwdriver and a fine, thin, soft cloth you can clean in between the keypad to remove dirt and debris.
    • By using a small standard screwdriver and a fine, thin, soft cloth you can clean in between the keypad to remove dirt and debris.

结论

To reassemble your device, follow these instructions in reverse order.

另外一个人完成了本指南。

Joe Cavaletto

于2011年01月30日注册

101 信誉积分

撰写一个指南

团队

Cal Poly, Team 11-23, Maness Winter 2011 Cal Poly, Team 11-23, Maness Winter 2011 的会员

CPSU-MANESS-W11S11G23

4 名成员

创作了10篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 0

过去的30天: 0

总计 849