简介

A loose steering box can be dangerous, especially when trying to stay in a lane on a windy highway. There are a number of components in the steering system that can wear, and cause play in the steering wheel. Before assuming its the steering box causing looseness, lie under the front of the car and have a friend move the wheel back and forth in the range of play. If the arm on the steering box does not move back and forth, then it is internal wear, so continue with the procedure.

配件

无需配件。

Open the (front) hood of the car.
  • Open the (front) hood of the car.

  • On the drivers side of the luggage compartment is a black seal.

添加评论

Remove the black seal.
  • Remove the black seal.

  • Under the seal is the adjustment screw and locking nut.

添加评论

  • If the screw threads do not rise above the locking nut then STOP: The steering box is worn out, it is time to rebuild it, or replace it! Failure to do so could result in your steering system failing.

  • Loosen the Locking nut, so the set screw can be turned with a flat head screwdriver.

  • With the wheels straight and the steering wheel centered. Turn the lash adjustment screw clockwise until it stops, but don't force it any farther!

  • Making sure that the screw does not turn, carefully tighten the locking nut.

添加评论

  • Close the hood, drive around and check the steering wheel play.

  • If the play is still too loose, then repeat steps 2 and 3.

  • If the steering wheel does not return to center after making a turn then it is too tight. This can cause unnecessary wear and damage your steering box! Return to step 2, but instead of tightening the lash screw, loosen it a quarter turn at a time and recheck.

添加评论

结论

Congratulations! Your steering box should now have a minimal amount of play!

2等其他人完成本指南。

Noah

于2012年10月03日注册

451 信誉积分

创作了6篇指南

团队

Cal Poly, Team 6-33, Regan Fall 2012 Cal Poly, Team 6-33, Regan Fall 2012 的会员

CPSU-REGAN-F12S6G33

3 名成员

创作了7篇指南

I have over tighten the steering box. I have loosen the box all the way ,but it steel stick

larryboyd23 - 回复

This procedure skips several important steps, including setting the preload prior to adjusting the lash screw. Hint - you need a torque wrench to do it correctly. It's also advisable to check all the steering components, especially the pitman arm bushing, as the cause of steering play before blaming the steering box. I've seen several steering boxes ruined by over tightening the lash screw when the box wasn't even the problem to begin with.

Jim Thomas - 回复

great post, thanks for sharing it. Keep Posting.

https://www.sarexports.com/product/steer...

Raman Malik - 回复

添加评论

浏览统计数据:

过去的24小时: 8

过去的7天: 27

过去的30天: 163

总计 22,092