跳转到主内容

修复你的物品

维修的权力

商店

简介

This guide will walk you through the quick and simple process of assembling a Mac Pro First Generation Hard Drive Sled Adapter. The existing hard drive bay sled brackets in this device are meant to fit 3.5" hard drives, but this adapter enables you to install any SATA 2.5" solid state, hybrid, or standard hard drive. It also correctly aligns the SATA connector to match the socket in your Mac Pro.

配件

没有特定配件。

  1. Insert the two tabs on the left side of the metal adapter bracket into the slots on the left side of the hard drive bay sled. Align the holes on the right side. Align the holes on the right side.
    • Insert the two tabs on the left side of the metal adapter bracket into the slots on the left side of the hard drive bay sled.

    • Align the holes on the right side.

  2. Screw the two 7.8mm PH0 screws into the two holes on the right.
    • Screw the two 7.8mm PH0 screws into the two holes on the right.

    • Leave these screws slightly loose; they will be tightened once the hard drive is attached.

  3. Align the holes in the hard drive with the three holes on the bracket. Screw the three 6.1mm PH0 screws into the bracket and hard drive. These screws can be secured tightly.
    • Align the holes in the hard drive with the three holes on the bracket.

    • Screw the three 6.1mm PH0 screws into the bracket and hard drive.

    • These screws can be secured tightly.

  4. Tighten the two 7.8mm PH0 screws on the right side of the bracket.
    • Tighten the two 7.8mm PH0 screws on the right side of the bracket.

终点

Kristen Gismondi

于2014年11月12日注册

40,600 信誉积分

创作了72篇指南

团队

iFixit iFixit 的会员

Community

135 名成员

创作了13,904篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 0

过去的30天: 0

总计 54