简介

This guide is created to replace a damaged or broken back wheel. Tools required are a Hex Bit 4.0 tool, a bit extender, and an allen key.

配件

无需配件。

  1. Remove either of the two 0.2 mm axle screws by using a hex bit 4.0 by turning clockwise.
    • Remove either of the two 0.2 mm axle screws by using a hex bit 4.0 by turning clockwise.

    • The two screws are the same thread so find the screw that has the least torque. Only that screw will be able to removed in this step.

    • Turn the hex bit 4.0 counterclockwise to reassemble the axle screws.

    添加评论

  2. Slide off the plastic side panel.
    • Slide off the plastic side panel.

    添加评论

  3. 传播 Fixmas 欢乐
    Get $12 off your purchase of $50 or more with code FIXMAS12
    传播 Fixmas 欢乐
    Get $12 off your purchase of $50 or more with code FIXMAS12
    • Use a hex bit 4.0 to screw back in the 0.2 mm screw as tightly as possible by turning clockwise.

    • You will need to hold the other screw you are not replacing with an additional hex bit 4.0, so that the screws don't spin freely.

    添加评论

    • Flip over the scooter and use the hex bit 4.0 to remove the other 0.2 mm screw.

    添加评论

    • Slide off the other plastic side panel.

    添加评论

    • On the same side you removed the screw, use the bit extender to push down on the axle inside the wheel.

    • The axle pops out and the wheel easily comes off.

    • Two washers will pop out with the axle.

    添加评论

结论

To reassemble your device, follow these instructions in reverse order.

Luke Imai

于2018年10月08日注册

133 信誉积分

撰写一个指南

团队

Cal Poly, Team S15-G5, White Fall 2018 Cal Poly, Team S15-G5, White Fall 2018 的会员

CPSU-WHITE-F18S15G5

4 名成员

创作了5篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 1

过去的30天: 17

总计 33