简介

To fully access all parts of the Hover-1 Chrome, the entirety of the outer shell must be removed. This guide will go over how to completely remove the outer shell.

配件

无需配件。

  1. Flip the Hover-1 Chrome upside down.
    • Flip the Hover-1 Chrome upside down.

    • Use a Phillips #2 screwdriver to remove the fourteen 14 mm screws from the bottom of the Hover-1.

    • Break the two black tape circles, and remove the two 15 mm Phillips screws underneath.

    添加评论

  2. Lift the shell without the speaker grille and unplug the battery.
    • Lift the shell without the speaker grille and unplug the battery.

    添加评论

    • Lift the shell with the speaker grille.

    • Unplug the speaker.

    • Unplug the LEDs.

    • Unplug the power button

    • Unplug the charging port.

    添加评论

  3. GIVE TOOLS. FIX FOREVER.

    GIVE TOOLS.

    FIX FOREVER.

    Spread the Fixmas cheer.

    GIVE TOOLS. FIX FOREVER.

    Spread the Fixmas cheer.

    • Remove the twelve 14 mm Phillips #2 screws holding the top shell on.

    • The other six screws are on the side without the battery.

    添加评论

    • Free the cables held atop the bracket holding the battery in place.

    • Remove the four 14 mm Phillips #2 screws holding the battery bracket in place.

    • Pull the battery bracket free.

    添加评论

    • Unplug the cords for the top LEDs.

    • The other side of the board is structurally symmetrical. However instead of going under the battery bracket, these cords go through a zip tie. These cables must be removed from the zip tie in order to continue.

    添加评论

    • Turn the board over and pull the top panel off.

    添加评论

终点

Dylan Prins

于2018年10月08日注册

209 信誉积分

撰写一个指南

团队

Cal Poly, Team S4-G1, White Fall 2018 Cal Poly, Team S4-G1, White Fall 2018 的会员

CPSU-WHITE-F18S4G1

4 名成员

创作了6篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 12

过去的30天: 12

总计 22