跳转到主内容

简介

If you have looked at the troubleshooting page and identified that your issues with your Onyx Studio 2 are indeed due to the circuit board being bad, this guide will walk you through how to replace it.

  1. Using a plastic opening tool, pry off the front grill by wedging it in the notch on the front of the device. Using a plastic opening tool, pry off the front grill by wedging it in the notch on the front of the device. Using a plastic opening tool, pry off the front grill by wedging it in the notch on the front of the device.
    • Using a plastic opening tool, pry off the front grill by wedging it in the notch on the front of the device.

  2. Remove the five 14.4 mm T10 Torx screws. Remove the five 14.4 mm T10 Torx screws.
    • Remove the five 14.4 mm T10 Torx screws.

  3. Gently pull the front apart from the back.
    • Gently pull the front apart from the back.

  4. Remove the four wires connecting the front and back panels. Pinch the connector tab and pull gently upwards.
    • Remove the four wires connecting the front and back panels.

    • Pinch the connector tab and pull gently upwards.

    • Repeat for the other three connectors.

  5. Pull the silicone button band off of the outer edge of the speaker.
    • Pull the silicone button band off of the outer edge of the speaker.

  6. Disconnect the two pressure connections from the circuit board. Disconnect the two pressure connections from the circuit board.
    • Disconnect the two pressure connections from the circuit board.

  7. Gently remove the control board band by placing fingers in contact with it through the button openings. Work from the outer edges in so as not to bend the band.
    • Gently remove the control board band by placing fingers in contact with it through the button openings.

    • Work from the outer edges in so as not to bend the band.

  8. Disconnect the remaining connectors from the circuit board. Disconnect the Bluetooth antenna.
    • Disconnect the remaining connectors from the circuit board.

    • Disconnect the Bluetooth antenna.

  9. Remove the four 10 mm T10 Torx screws. Pull the circuit board out of the device as it is now free.
    • Remove the four 10 mm T10 Torx screws.

    • Pull the circuit board out of the device as it is now free.

结论

To reassemble your device, follow these instructions in reverse order.

8等其他人完成本指南。

Alexandra Achtenberg

于2017年02月02日注册

1,701 信誉积分

创作了6篇指南

团队

USF Tampa, Team 16-5, Blackwell Spring 2017 USF Tampa, Team 16-5, Blackwell Spring 2017 的会员

USFT-BLACKWELL-S17S16G5

3 名成员

创作了24篇指南

4条评论

Where do I get another one

Adrian tlahuel - 回复

Where we buy the board?

Eric Therrien - 回复

Umm… this was rather anticlimactic. Last step was basically like “and now contemplate your life choices”.

markcendan - 回复

Where can I Buy a new hk onix studio Main board?

tecnologia en localizaciòn - 回复

添加评论

浏览统计数据:

过去的24小时: 5

过去的7天: 24

过去的30天: 140

总计 16,484