简介

This guide will help you replace the buttons or the charging indicator. Buttons can wear out over time or stop working. Charging indicators might not light for electrical wiring reasons. A plastic opening tool and a PH0 screwdriver will be needed to remove the buttons/charging indicators.

  1. Using the plastic opening tool, to open the back panel of the device.
    • Using the plastic opening tool, to open the back panel of the device.

    • Push down on the plastic opening tool, and push the back panel, repeat this for the 4 sides of the device.

    添加评论

  2. Using the PH0 screw driver, remove the 7.5 mm screws by turning in  a clockwise direction. There are 6 screws on the front panel.
    • Using the PH0 screw driver, remove the 7.5 mm screws by turning in a clockwise direction. There are 6 screws on the front panel.

    • Remove all of the 7.5 mm screws, by repeating the same step above.

    • After unscrewing the 7.5 mm screws, just lift the plastic and you will see the motherboard.

    添加评论

    • The buttons will be on the side of the device, use the plastic opening tool to remove it from its actual place no need to use any screwdrivers.

    添加评论

    • Use the plastic opening tool to remove the indicator lights and replace them by new ones.

    添加评论

结论

To reassemble your device, follow these instructions in reverse order.

yousef aljeemaz

于2017年10月18日注册

573 信誉积分

创作了5篇指南

团队

USF Tampa, Team S1-G9, Cagle Fall 2017 USF Tampa, Team S1-G9, Cagle Fall 2017 的会员

USFT-CAGLE-F17S1G9

5 名成员

创作了5篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 2

过去的30天: 27

总计 447