简介

Use this guide to separate the back cover from the front.

  1. Remove the outer screen cover by releasing  the top clip from the main body of the device.
    • Remove the outer screen cover by releasing the top clip from the main body of the device.

    添加评论

  2. Pull out the stylus from the top right corner of the device.
    • Pull out the stylus from the top right corner of the device.

    添加评论

    • Slide the memory cartridge cover up and off the device.

    添加评论

    • Remove the battery cover by releasing the clip from the main body of the device.

    添加评论

    • Remove the batteries from the device.

    添加评论

    • Unscrew the four 2.94mm screws with a #00 Phillips screwdriver.

    • One end of the OEM stylus can unscrew and contains a mini #00 Phillips screwdriver.

    添加评论

    • Use the spudger to pry open the casing by applying pressure at 4 clips on both sides of the device.

    • Be careful while opening the casing as there is a flex strip connecting the two halves.

    添加评论

    • Disconnect the flex strip from the motherboard with tweezers.

    添加评论

结论

To reassemble your device, follow these instructions in reverse order.

另外一个人完成了本指南。

Robert

于2012年07月07日注册

23 信誉积分

撰写一个指南

团队

Cal Poly, Team 1-2, Regan SU 2012 Cal Poly, Team 1-2, Regan SU 2012 的会员

CPSU-REGAN-SU12S1G2

4 名成员

创作了6篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 2

过去的30天: 4

总计 356