配件

无需配件。

  1. Slide the silver release tab up and simultaneously lift the cover up from the left side.
    • Slide the silver release tab up and simultaneously lift the cover up from the left side.

    添加评论

  2. Push the tab from left to right to remove the cover.
    • Push the tab from left to right to remove the cover.

    添加评论

    • Now lift the battery up and away from the device to remove it.

    添加评论

    • Remove the four silver screws (T5 x .25 in).

    添加评论

    • Remove the single black screw (T5 x .125 in) beneath the HP sticker.

    添加评论

  3. Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    • Next, use your plastic removal tool to separate the gray back from the black center piece.

    • For better results, start the separation at the corner piece.

    添加评论

    • Remove the back case.

    添加评论

    • Now that the back cover is removed, remove the small screw (#00 Philips x .17) to the left of the SD card slot

    添加评论

    • Next you will need to unlock and remove the ribbon cable

    • Carefully pull back on both sides of the brown bar using metal tweezers, unlocking the cable and slipping it out of the connector

    • The bar, connector, and cable are fragile components that can be easily broken

    添加评论

    • Next you need to remove the wire off the bottom of the mother board

    • The easiest method is to use some metal tweezers and grip the plug close to the connector.

    • Make sure all these connections are properly disconnected before separation of the motherboard

    添加评论

    • Next use your plastic removal tool and separate the silver front case from the black frame.

    添加评论

    • Remove the 4 screws along the bottom of the faceplate

    • They are #00 Philips head screws

    添加评论

    • Once removed you can easily separate the keys from the body.

    添加评论

    • once the joypad key have been removed use the tweezers to carefully maneuver the wire out of its clip releasing the battery

    添加评论

结论

To reassemble your device, follow these instructions in reverse order.

另外一个人完成了本指南。

John Pagliero

于2011年01月27日注册

886 信誉积分

创作了7篇指南

团队

Cal Poly, Team 3-39, Regan Winter 2011 Cal Poly, Team 3-39, Regan Winter 2011 的会员

CPSU-REGAN-W11S3G39

4 名成员

创作了7篇指南

This guide is AWESOME.. Thanks! I have an iPAQ 1945 h1900, but this guide was the exact same for my device. I got as far as the taking the battery out without removing the 5th screw beneath the "warranty void" sticker. My only issue--do you know where to get the replacement battery?

Drew Stafford - 回复

添加评论

浏览统计数据:

过去的24小时: 1

过去的7天: 1

过去的30天: 32

总计 2,366